论文信息 - Contouring electrical discharge machining with on-machine measuring and dressing of a cylindrical graphite electrode

Contouring electrical discharge machining with on-machine measuring and dressing of a cylindrical graphite electrode

This paper presents a new approach of contouring electric discharge machining (EDM) by means of the on-machine measuring and dressing of a ball-nosed cylindrical graphite electrode. The on-machine measuring is done in order to detect electrode wear by a laser range sensor. The on-machine dressing is carried out by turning the electrode with a disk shaped cutting tool fixed in the EDM machine. Machining experiments by contouring EDM have been performed and their results are compared with those by diesinking EDM in terms of the total machining time, electrode cost and machining error. Their results support the efficiency and validity of contouring EDM.

Y. Mizugaki

[1] Yoshio Mizugaki,et al. Tool Path Generation Considering Cutting Speed in Milling Geometric Simulation , 1994 .

[2] Yoshio Mizugaki,et al. Development of CAM System Based on Enhanced Z-map Model. A New Method of an Offset Surface Generation. , 1994 .

[3] Naotake Mohri,et al. On-the-Machine Measurement in EDM Process by a Calibration System with Polyhedra , 1994 .

[4] Yoshio Mizugaki,et al. A Study of On-Machine Measurement with the Compensation of Probe Sensitivity in a Machine Tool , 1994, J. Robotics Mechatronics.

[5] Masanori Kunieda,et al. Observation of Arc Column Movement during Monopulse Discharge in EDM , 1992 .

[6] Takeshi Kishinami,et al. Development of Numerical Contouring Control Electric Discharge Machining (NCC-EDM) , 1986 .

[7] Manfred Weck,et al. Analysis and Adaptive Control of EDM Sinking Process Using the Ignition Delay Time and Fall Time as Parameter , 1992 .

[8] D. F. Dauw,et al. High-precision wire-EDM by online wire positioning control , 1994 .

[9] Kamlakar P Rajurkar,et al. WEDM Identification and Adaptive Control for Variable-Height Components , 1994 .