Finite element analysis for the mechanical features of resistance spot welding process

Abstract In this paper, a 2D axisymmetric model of thermo-elastic–plastic finite element method (FEM) is developed to analyze the mechanical behavior of resistance spot welding (RSW) process using commercial software ANSYS. A transient temperature field obtained from a prior performed thermal–electrical simulation of RSW process is applied as nodal load on the model. The temperature-dependent properties and plastic behavior of materials are taken into account during the simulation. The distributions and changes of the contact pressure at both the faying surface and the electrode–workpiece interface are obtained through the analysis. The stress and strain distributions in the weldment and their changes during the RSW process are determined. The deformation of the weldment and the electrode displacement are also calculated.

[1]  M. Mochizuki,et al.  A Predicting Method of Welding Residual Stress Using Source of Residual Stress (Report IV) : Experimental Verification for Predicting Method of Welding Residual Stresses in T-joints Using Inherent Strains(Mechanics, Strength & Structural Design) , 1993 .

[2]  Baohua Chang,et al.  Numerical study on the effect of electrode force in small-scale resistance spot welding , 2003 .

[3]  O. P. Gupta,et al.  An Improved Numerical Modeling for Resistance Spot Welding Process and Its Experimental Verification , 1998 .

[4]  Yung-Li Lee,et al.  Evaluation of multiaxial spot weld fatigue parameters for proportional loading , 2000 .

[5]  H. Nied.  The finite element modeling of the resistance spot welding Process , 1984 .

[6]  Ning Pan,et al.  Spot welds fatigue life prediction with cyclic strain range , 2002 .

[7]  Wei Chen,et al.  Three-dimensional finite element analysis of the mechanical behavior of spot welds , 2000 .

[8]  Daniel Richard,et al.  Carbon to cast iron electrical contact resistance constitutive model for finite element analysis , 2003 .

[9]  Tau Tyan,et al.  A general failure criterion for spot welds under combined loading conditions , 2003 .

[10]  David W. Dickinson,et al.  Analysis and development of a real-time control methodology in resistance spot welding , 1991 .

[11]  Yuh J. Chao,et al.  Ultimate Strength and Failure Mechanism of Resistance Spot Weld Subjected to Tensile, Shear, or Combined Tensile/Shear Loads , 2003 .

[12]  J. Gilgert,et al.  Fatigue life duration prediction for welded spots by volumetric method , 2004 .

[13]  Jamil A. Khan,et al.  Numerical Simulation of Resistance Spot Welding Process , 2000 .

[14]  P. H. Thornton,et al.  Transient thermal analysis of spot welding electrodes , 1999 .