论文信息 - Computer-Aided Wire Drawing

Computer-Aided Wire Drawing

Summary Current studies on mechanics of cold wire Drawing provide a comprehensive picture of the effects of main parameters on he basic process. However at production floor level multipass Drawing still exhibits a number of tough problems. Scatter in wire properties, defects, lubricant decay, irregular die wear may affect product quality and upset production schedule. By combining experimental evidence with theoretical and numerical models of the basic friction and deformation process into a global description of multipass machine operation, taking into account stochastic process properties, production planning procedure may be effectively supported, and reliable guidelines for process control and troubleshooting are obtained.

[1] C. Yang. On the Mechanics of Wire Drawing , 1961 .

[2] Betzalel Avitzur,et al. Analysis of Wire Drawing and Extrusion Through Conical Dies of Large Cone Angle , 1963 .

[3] Betzalel Avitzur,et al. Analysis of Central Bursting Defects in Extrusion and Wire Drawing , 1968 .

[4] Betzalel Avitzur,et al. Flow Characteristics Through Conical Converging Dies , 1966 .

[5] A. Atkins,et al. The Influence of Redundant Work When Drawing Rods Through Conical Dies , 1968 .

[6] C. C. Chen,et al. Ductile Fracture in Axisymmetric Extrusion and Drawing—Part 1: Deformation Mechanics of Extrusion and Drawing , 1977 .

[7] Betzalel Avitzur,et al. Analysis of the Effect of Strain Hardening on Central Bursting Defects in Drawing and Extrusion , 1970 .

[8] J. G. Wistreich. Investigation of the Mechanics of Wire Drawing , 1955 .

[9] E. G. Thomsen,et al. A Drawing Modulus for Multi-Pass Drawing , 1986 .

[10] Betzalel Avitzur,et al. Strain-Hardening and Strain-Rate Effects in Plastic Flow Through Conical Converging Dies , 1967 .