Thermal insulation performance of aerated lightweight concrete

Building envelopes that insulate buildings against heat and cold are receiving increasing attention as a promising passive energy-efficient measure in building construction. The experimental study reported here evaluates the thermal insulation performance of aerated lightweight concrete of different densities produced by incorporating either 100% sand or 100% soil as filler. Experimental aerated lightweight concrete wall panels (750 mm long, 750 mm wide and 40 mm thick) were cast and tested. Both soil-based and sand-based (control) aerated lightweight concrete panels were cured in a room with a prevailing temperature of approximately 29°C. The temperature gradient for soil-based aerated lightweight concrete panels was found to be superior to that of control aerated lightweight concrete panels of comparable density. The results indicate the potential improvement of soil-based aerated lightweight concrete in terms of thermal insulation compared with sand-based aerated lightweight concrete.

[1]  Ronald D. Neufeld,et al.  Thermal inertia properties of autoclaved aerated concrete , 1999 .

[2]  K. Ramamurthy,et al.  Models relating mixture composition to the density and strength of foam concrete using response surface methodology , 2006 .

[3]  K. Ramamurthy,et al.  A classification of studies on properties of foam concrete , 2009 .

[4]  F. Özcan,et al.  High-strength lightweight concrete made with scoria aggregate containing mineral admixtures , 2003 .

[5]  Agis M. Papadopoulos,et al.  Environmental performance evaluation of thermal insulation materials and its impact on the building , 2007 .

[6]  Joseph Khedari,et al.  New lightweight composite construction materials with low thermal conductivity , 2001 .

[7]  Ramazan Demirboga,et al.  Influence of mineral admixtures on thermal conductivity and compressive strength of mortar , 2003 .

[8]  Ramazan Demirboga,et al.  The effects of expanded perlite aggregate, silica fume and fly ash on the thermal conductivity of lightweight concrete , 2003 .

[9]  Phillip John Jones,et al.  Thermophysical properties of stabilised soil building blocks , 1995 .

[10]  William J. Orts,et al.  Starch-based lightweight concrete: effect of starch source, processing method, and aggregate geometry , 1999 .

[11]  J. Ayala,et al.  Characteristics and properties of lightweight concrete manufactured with cenospheres , 2000 .

[12]  E. Kearsley,et al.  The effect of porosity on the strength of foamed concrete , 2002 .

[13]  Haji Hassan Masjuki,et al.  CORRELATION BETWEEN THERMAL CONDUCTIVITY AND THE THICKNESS OF SELECTED INSULATION MATERIALS FOR BUILDING WALL , 2007 .

[14]  Ramazan Demirboga,et al.  Thermo-mechanical properties of sand and high volume mineral admixtures , 2003 .

[15]  N. Abu‐Hamdeh,et al.  Soil Thermal Conductivity Effects of Density, Moisture, Salt Concentration, and Organic Matter , 2000 .