Design of a direct conversion ultra low power ZigBee receiver RF front-end for wireless sensor networks

This paper describes an ultra low power receiver RF front-end to be utilized for wireless sensor network (WSN) applications. The design of the LV cell (LNA and VCO) that is proposed in this paper is suitable for direct conversion architecture, while the conventional LMV cell (LNA, Mixer, and VCO) is used only in low-IF architectures, due to the prohibitive high flicker noise. A passive mixer is utilized instead of an active mixer and a capacitor is added to block the DC current flowing into the mixer. So, flicker noise corner frequency is reduced to 13.8kHz. The proposed design can be used more easily compared to conventional LMV cell in a low voltage technology, because of the stacking of only two blocks (LNA and VCO), while three blocks of LNA, mixer, and VCO are stacked in the conventional LMV cell. The proposed receiver RF front-end consumes 1mW in 0.18@mm CMOS technology with a 1.2V supply source. NF and IIP3 are 4.7dB and -7dBm, respectively.

[1]  Sang-Gug Lee,et al.  A low-phase noise LC-QVCO in CMOS technology , 2004, IEEE Microwave and Wireless Components Letters.

[2]  Samad Sheikhaei,et al.  A new high linearity LMV based receiver front-end for IEEE 802.15.4 applications , 2011, 2011 19th Iranian Conference on Electrical Engineering.

[3]  Behzad Razavi,et al.  RF Microelectronics , 1997 .

[4]  Sang-Gug Lee,et al.  A low-power CMOS direct conversion receiver with 3-dB NF and 30-kHz flicker-noise corner for 915-MHz band IEEE 802.15.4 ZigBee standard , 2006 .

[5]  Seok-Kyun Han,et al.  Current-Reused Ultra Low Power, Low Noise LNA${+}$Mixer , 2009, IEEE Microwave and Wireless Components Letters.

[6]  Amr Amin Hafez,et al.  Design of a low-power ZigBee receiver front-end for wireless sensors , 2007, 2007 Internatonal Conference on Microelectronics.

[7]  R. Castello,et al.  Single-Stage Low-Power Quadrature RF Receiver Front-End: The LMV Cell , 2006, IEEE Journal of Solid-State Circuits.

[8]  Young-Jin Kim,et al.  A Switchless Zigbee Frontend Transceiver With Matching Component Sharing of LNA and PA , 2010, IEEE Microwave and Wireless Components Letters.

[9]  Sang-Gug Lee,et al.  A CMOS 868/915 MHz direct conversion. ZigBee single-chip radio , 2005, IEEE Communications Magazine.

[10]  Peter R. Kinget,et al.  A 0.6-V Zero-IF/Low-IF Receiver With Integrated Fractional-N Synthesizer for 2.4-GHz ISM-Band Applications , 2010, IEEE Journal of Solid-State Circuits.

[11]  Antonio Liscidini,et al.  Low-Power Quadrature Receivers for ZigBee (IEEE 802.15.4) Applications , 2010, IEEE Journal of Solid-State Circuits.

[12]  Sang-Gug Lee,et al.  Building a 2.4-GHZ radio transceiver using IEEE 802.15.4 , 2006, IEEE Circuits and Devices Magazine.