Flow Stress Prediction Model and Its Application

To improved the prediction accuracy of the flow stress, a hybrid model based on the Hybrid Least Squares Support Vector Machine (HLS-SVM) and Mathematical Models (MM) was proposed. In HLS-SVM model, the optimal parameters of LS-SVM were obtained by self- adaptive Particle Swarm Optimization (PSO)based on Simulated Annealing (SA). Simulation experiment results revealed that this model could correctly recur to the flow stress in the sample data and accurately predict the non- sample data. The efficiency and accuracy of the predicted flow stress achiieved by the proposed model were better than the methods used in most literature. Index Terms:least square support vector machine ;particle swarm optimization; simulated annealing;flow stress

[1]  Pasquale Cavaliere,et al.  Compressive plastic deformation of an AS21X magnesium alloy produced by high pressure die casting at elevated temperatures , 2004 .

[2]  Johan A. K. Suykens,et al.  Least Squares Support Vector Machine Classifiers , 1999, Neural Processing Letters.

[3]  P. Zhang,et al.  Influence of shot peening on high cycle fatigue properties of the high-strength wrought magnesium alloy AZ80 , 2005 .

[4]  Hirohiko Takuda,et al.  Modelling of formula for flow stress of a magnesium alloy AZ31 sheet at elevated temperatures , 2005 .

[5]  Prasad K. Yarlagadda,et al.  Neural network approach to flow stress evaluation in hot deformation , 1995 .

[6]  Hamid Garmestani,et al.  Prediction of nonlinear viscoelastic behavior of polymeric composites using an artificial neural network , 2006 .

[7]  Jie Zhou,et al.  Determination of a constitutive relationship for AZ31B magnesium alloy and validation through comparison between simulated and real extrusion , 2006 .

[8]  Li Ping,et al.  Neural network prediction of flow stress of Ti–15–3 alloy under hot compression , 2004 .

[9]  M. P. Phaniraj,et al.  The applicability of neural network model to predict flow stress for carbon steels , 2003 .

[10]  C. M. Sellars,et al.  Constitutive equations for high temperature flow stress of aluminium alloys , 1997 .

[11]  Hitoshi Fujimoto,et al.  Modelling on flow stress of Mg–Al–Zn alloys at elevated temperatures , 1998 .

[12]  Rajiv Shivpuri,et al.  Modeling flow stress of magnesium alloys at elevated temperature , 2006 .

[13]  John J. Jonas,et al.  Mathematical Modeling of the Mean Flow Stress, Fractional Softening and Grain Size during the Hot Strip Rolling of C-Mn Steels , 1996 .

[14]  Z. Trojanová,et al.  Compressive deformation behaviour of magnesium alloys , 2005 .