Experiments for Hydrogen Chloride Transport and Decay in a Simulated Heating, Ventilating and Air Conditioning System and Comparison of the Results with Predictions from a Theoretical Model

The transport of hydrogen chloride (HCl) gas in air was studied in a simulated heating, ventilating and air conditioning (HVAC) system. The test system was a tube of square cross section, 0.305 m (1 ft) on each side, with a total length of ca. 120 m. The sides of the apparatus were built of painted and unpainted gypsum wallboard, and poly(methyl methacrylate) (PMMA), ar ranged in two different configurations. All four tests were run at normal room temperature. Hydrogen chloride gas was injected into the air at the entrance to yield initial HCl concentrations of ca. 3,000-4,000 ppm (vol). The experiments were typically conducted for 30 min. Gaseous HCl concentrations were mea sured at 9 locations along the conduit, and the results were compared with pre dictions from an existing model for HCl transport and decay from fire at mospheres. The model was used in a purely predictive mode, i.e., unchanged, since the flow dynamics are well defined in this scenario and since HCl decay parameters for each type of surface used had been developed for the model in previous studies.

[1]  F. Galloway,et al.  Hydrogen chloride release from poly(vinyl chloride): model for its decay , 1987 .

[2]  Marcelo M. Hirschler,et al.  Hydrogen Chloride Transport and Decay in a Large Apparatus I. Decomposition of Poly(Vinyl Chloride) Wire Insulation in a Plenum by Current Overload , 1986 .

[3]  M. Hirschler.  Thermal decomposition (STA and DSC) of PVC compounds under a variety of atmospheres and heating rates , 1986 .

[4]  Robert E. Wilson,et al.  Fundamentals of momentum, heat, and mass transfer , 1969 .

[5]  A. Grand,et al.  Hydrogen Chloride Transport and Decay in a Large Apparatus: II. Variables Affecting Hydrogen Chloride Decay , 1987 .

[6]  Marcelo M. Hirschler,et al.  A model for the spontaneous removal of airborne hydrogen chloride by common surfaces , 1989 .

[7]  Richard D. Peacock,et al.  Technical Reference Guide for FAST Version 18. Final Report (NIST TN 1216) , 1989 .

[8]  A. Hindmarsh.  LSODE and LSODI, two new initial value ordinary differential equation solvers , 1980, SGNM.

[9]  S. C. Packham,et al.  An Evaluation of Smoke Toxicity and Toxic Hazard of Electrical Nonmetallic Tubing Combustion Products , 1984 .

[10]  F. B. Hildebrand,et al.  Introduction To Numerical Analysis , 1957 .

[11]  Marcelo M. Hirschler,et al.  Transport and decay of hydrogen chloride: Use of a model to predict hydrogen chloride concentrations in fires involving a room-corridor-room arrangement , 1990 .

[12]  V. Esch,et al.  Polyvinyl chloride toxicity in fires. Hydrogen chloride toxicity in fire fighters. , 1976, Journal of the American Medical Association (JAMA).

[13]  T G Lee,et al.  SMOKE AND GASES PRODUCED BY BURNING AIRCRAFT INTERIOR MATERIALS. , 1969 .

[14]  M. M. O'mara.  Combustion of PVC , 1977 .

[15]  C. F. Cullis,et al.  The combustion of organic polymers , 1981 .

[16]  S. K. Brown,et al.  Toxic gas and smoke measurement with the British fire propagation test I. Test conditions , 1985 .

[17]  K. G. Martin,et al.  Toxic gas and smoke assessment studies on vinyl floor covering with the fire propagation test , 1979 .

[18]  A. Grand.  Continuous Monitoring of Hydrogen Chloride in Combustion Atmospheres and in Air , 1988 .