Prediction of subcooled flow boiling characteristics using two-fluid Eulerian CFD model
暂无分享,去创建一个
Francisco A. Braz Filho | Guilherme B. Ribeiro | Alexandre D. Caldeira | G. Ribeiro | F. B. Filho | A. D. Caldeira
[1] Hidesada Tamai,et al. Transverse migration of single bubbles in simple shear flows , 2002 .
[2] Mohamed A. Habib,et al. Numerical predictions of flow boiling characteristics: Current status, model setup and CFD modeling for different non-uniform heating profiles , 2015 .
[3] Wenxi Tian,et al. Prediction of CHF in vertical heated tubes based on CFD methodology , 2015 .
[4] Yanzhong Li,et al. CFD simulation of upward subcooled boiling flow of refrigerant-113 using the two-fluid model , 2009 .
[5] V. Dhir. Complete Numerical Simulation of Subcooled Flow Boiling in the Presence of Thermal and Chemical Interactions , 2003 .
[6] J. Flaherty,et al. Analysis of phase distribution in fully developed laminar bubbly two-phase flow , 1991 .
[7] Robert Cole,et al. A photographic study of pool boiling in the region of the critical heat flux , 1960 .
[8] Yassin A. Hassan,et al. A two-equation turbulence model of turbulent bubbly flows , 2001 .
[9] Vijay K. Dhir,et al. Interfacial heat transfer during subcooled flow boiling , 2002 .
[10] Michael Z. Podowski,et al. MULTIDIMENSIONAL EFFECTS IN FORCED CONVECTION SUBCOOLED BOILING , 1990 .
[11] D. Kenning,et al. Subcooled flow boiling at high heat flux , 1985 .
[12] N. Zuber,et al. Drag coefficient and relative velocity in bubbly, droplet or particulate flows , 1979 .
[13] I. Kljenak,et al. Modelling of local two-phase flow parameters in upward subcooled flow boiling at low pressure , 2004 .
[14] V. I. Tolubinsky,et al. VAPOUR BUBBLES GROWTH RATE AND HEAT TRANSFER INTENSITY AT SUBCOOLED WATER BOILING , 1970 .
[15] Eckhard Krepper,et al. CFD modelling of subcooled boiling—Concept, validation and application to fuel assembly design , 2007 .
[16] Henryk Anglart,et al. CFD prediction of flow and phase distribution in fuel assemblies with spacers , 1997 .
[17] Iztok Tiselj,et al. Influence of near-wall modelling on boiling flow simulation , 2010 .
[18] Martha Salcudean,et al. Bubble behavior in subcooled flow boiling of water at low pressures and low flow rates , 2002 .
[19] D. Bestion,et al. Applicability of two-phase CFD to nuclear reactor thermalhydraulics and elaboration of Best Practice Guidelines , 2012 .
[20] E. Lorenzini,et al. A simplified method proposal for practical determination of aperiodic two-phase flow instability , 1981 .
[21] Huiying Li,et al. Prediction of Boiling and Critical Heat Flux Using an Eulerian Multiphase Boiling Model , 2011 .
[22] D. Bestion,et al. The difficult challenge of a two-phase CFD modelling for all flow regimes , 2014 .
[23] Vijay K. Dhir,et al. Wall Heat Flux Partitioning During Subcooled Flow Boiling: Part 1—Model Development , 2005 .
[24] G. Cubizolles,et al. LOCAL MEASUREMENTS ON FLOW BOILING OF REFRIGERANT 12 IN A VERTICAL TUBE , 2001 .
[25] D. S. Trent,et al. COBRA-IV: the model and the method , 1977 .
[26] J. Thome,et al. Convective Boiling and Condensation , 1972 .