A RF to DC Voltage Conversion Model for Multi-Stage Rectifiers in UHF RFID Transponders

This paper presents a RF to DC conversion model for multi-stage rectifiers in UHF RFID transponders. An equation relating the RF power available from the antenna to the DC output voltage produced by a multi-stage rectifier is presented. The proposed model includes effects of the nonlinear forward voltage drop in diodes and impedance matching conditions of the antenna to rectifier interface. Fundamental frequency impedance approximation is used to analyze the resistance of rectifying diodes; parasitic resistive loss components are also included in the analysis of rectifier input resistance. The closed form equation shows insights into design parameter tradeoffs, such as power available from the antenna, antenna radiation resistance, the number of diodes, DC load current, parasitic resistive loss components, diode and capacitor sizes, and frequency of operation. Therefore, it enables the optimization of rectifier parameters for impedance matching with a low-cost printed antenna and shunt tuning inductor, in order to improve the RF to DC conversion efficiency and the operational distance of UHF RFID transponders. Three diode doublers and three multistage rectifiers were fabricated in a 130 nm CMOS process with custom no-mask added Schottky diodes. Measurements of the test IC are in good agreement with the proposed model.

[1]  Klaus Finkenzeller,et al.  Book Reviews: RFID Handbook: Fundamentals and Applications in Contactless Smart Cards and Identification, 2nd ed. , 2004, ACM Queue.

[2]  M. Usami.  An ultra small RFID chip: /spl mu/-chip , 2004, 2004 IEE Radio Frequency Integrated Circuits (RFIC) Systems. Digest of Papers.

[3]  Martin Fischer,et al.  Fully integrated passive UHF RFID transponder IC with 16.7-μW minimum RF input power , 2003, IEEE J. Solid State Circuits.

[4]  M. Usami.  An ultra-small RFID chip: /spl mu/-chip , 2004, Proceedings of 2004 IEEE Asia-Pacific Conference on Advanced System Integrated Circuits.

[5]  Thomas H. Lee,et al.  The Design of CMOS Radio-Frequency Integrated Circuits: RF CIRCUITS THROUGH THE AGES , 2003 .

[6]  C. Dehollain,et al.  Remotely powered addressable UHF RFID integrated system , 2005, IEEE Journal of Solid-State Circuits.

[7]  Chi-Ying Tsui,et al.  Analysis and Design Strategy of UHF Micro-Power CMOS Rectifiers for Micro-Sensor and RFID Applications , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[8]  S. Lazar,et al.  Design of multistage rectifiers with low-cost impedance matching for passive RFID tags , 2006, IEEE Radio Frequency Integrated Circuits (RFIC) Symposium, 2006.

[9]  G. Iannaccone,et al.  Design criteria for the RF section of UHF and microwave passive RFID transponders , 2005, IEEE Transactions on Microwave Theory and Techniques.

[10]  Ron Oliver,et al.  Design of ultra-low-cost UHF RFID tags for supply chain applications , 2004, IEEE Communications Magazine.

[11]  Robert G. Harrison.  Full nonlinear analysis of detector circuits using Ritz-Galerkin theory , 1992, 1992 IEEE Microwave Symposium Digest MTT-S.

[12]  J. F. Dickson,et al.  On-chip high-voltage generation in MNOS integrated circuits using an improved voltage multiplier technique , 1976 .

[13]  H. Yoshida,et al.  A 950-MHz rectifier circuit for sensor network tags with 10-m distance , 2006, IEEE Journal of Solid-State Circuits.