Factors contributing to ageing of high voltage carbon/carbon supercapacitors in salt aqueous electrolyte

Accelerated ageing based on floating has been used to investigate the state of health of high voltage carbon/carbon capacitors in aqueous Li2SO4 electrolyte and to determine the factors influencing their life-time. A pressure sensor connected to the cell allowed to measure gas evolution caused by overcharging of the system and to determine the maximum operating voltage limit of the cell. At voltage higher than 1.5 V, gases started to evolve, together with oxidation of the positive carbon electrode material and formation of decomposition and/or corrosion products. The positive electrode was found to entail the ageing of the entire system, being covered by twice more surface oxygenated groups than the negative one after 120 h of floating at 1.7 V. The blockage of pore entrances by oxygenated surface functionalities decreases the accessible pore volume, causing a decrease of capacitance and an increase of internal resistance during floating. A drop of capacitive current is observed at voltage higher than 1.2 V on the voltammograms already after 20 h floating at 1.7 V. From the study, it can be concluded that the AC/AC supercapacitors using aqueous Li2SO4 with stainless steel current collectors can operate safely up to 1.5 V, which is actually much more than the voltage value of 0.8–1 V reached with aqueous KOH and H2SO4 electrolytes.

[1]  F. Béguin,et al.  A symmetric carbon/carbon supercapacitor operating at 1.6 V by using a neutral aqueous solution , 2010 .

[2]  彭文杰,et al.  Effect of activated carbon and electrolyte on properties of supercapacitor , 2007 .

[3]  Grzegorz Lota,et al.  Novel insight into neutral medium as electrolyte for high-voltage supercapacitors , 2012 .

[4]  B. Conway.  Electrochemical Supercapacitors: Scientific Fundamentals and Technological Applications , 1999 .

[5]  Dominique Massiot,et al.  Causes of supercapacitors ageing in organic electrolyte , 2007 .

[6]  F. Béguin,et al.  Saturation of subnanometer pores in an electric double-layer capacitor , 2009 .

[7]  J. Figueiredo,et al.  Modification of the surface chemistry of activated carbons , 1999 .

[8]  V. Ruiz,et al.  Long-term cycling of carbon-based supercapacitors in aqueous media , 2009 .

[9]  Jim Drew.  Supercapacitors can replace a backup battery for power ride-through applications , 2015 .

[10]  Zhixing Wang,et al.  Effect of activated carbon and electrolyte on properties of supercapacitor , 2007 .

[11]  W. Yuan,et al.  Characterization of surface oxygen complexes on carbon nanofibers by TPD, XPS and FT-IR , 2007 .

[12]  Alexander Wokaun,et al.  Aging of electrochemical double layer capacitors with acetonitrile-based electrolyte at elevated voltages , 2010 .

[13]  Craig Underwood,et al.  Super-capacitor energy storage for micro-satellites: Feasibility and potential mission applications , 2013 .

[14]  A. Wokaun,et al.  A reliable determination method of stability limits for electrochemical double layer capacitors , 2013 .

[15]  B. Conway,et al.  Analysis of non-uniform charge/discharge and rate effects in porous carbon capacitors containing sub-optimal electrolyte concentrations , 2000 .

[16]  J. Figueiredo,et al.  Characterization of Active Sites on Carbon Catalysts , 2007 .

[17]  E. Morallón,et al.  Chemical and electrochemical characterization of porous carbon materials , 2006 .

[18]  K. J. Hüttinger,et al.  Surface-oxidized carbon fibers: I. Surface structure and chemistry , 1996 .

[19]  Mario Conte,et al.  Supercapacitors Technical Requirements for New Applications , 2010 .

[20]  A. Burke.  Ultracapacitors: why, how, and where is the technology , 2000 .

[21]  Wendy G. Pell,et al.  Voltammetry at a de Levie brush electrode as a model for electrochemical supercapacitor behaviour , 2001 .

[22]  Y. Yanga,et al.  Chemical and electrochemical ageing of carbon materials used in supercapacitor electrodes , 2008 .

[23]  Rüdiger Kötz,et al.  Aging and failure mode of electrochemical double layer capacitors during accelerated constant load tests , 2010 .

[24]  R. Kötz,et al.  Cycle versus voltage hold – Which is the better stability test for electrochemical double layer capacitors? , 2013 .