Real-Time Passive Control of Wave Energy Converters Using the Hilbert-Huang Transform

Abstract Passive loading is a suboptimal method of control for wave energy converters (WECs) that usually consists of tuning the power take-off (PTO) damping of the WEC to either the energy or the peak frequency of the local wave spectrum. Such approach results in a good solution for waves characterized by one-peak narrowband spectra. Nonetheless, real ocean waves are non-stationary by nature, and sea wave profiles with different spectral distribution occur in a specific location over time. Thus, the average energy absorption of passively controlled WECs tends to be low. In this paper, we propose a real-time passive control (PC) based on the Hilbert-Huang transform (HHT), where the PTO damping is time-varying and tuned to the instantaneous frequency of the wave excitation force. The instantaneous frequency is calculated by using the HHT, an analysis method for nonlinear and non-stationary signals that relies on the local characteristic time-scale of the signal. A performance comparison (in terms of energy absorption) of the proposed solution with the passive loading method is presented for a heaving system, in a variety of wave spectra. It is shown that a performance improvement of up to 21%, or 65%, is obtained for the proposed PC scheme, when it is compared to passive loading tuned to the energy, or the peak frequency of the spectrum, respectively. Real ocean waves off the west coast of Ireland are adopted in the simulations.

[1]  Tim Stallard,et al.  Time series analysis-based adaptive tuning techniques for a heaving wave energy converter in irregular seas , 2007 .

[2]  Marta Molinas,et al.  Exploring the Potential for Increased Production from the Wave Energy Converter Lifesaver by Reactive Control , 2013 .

[3]  W. E. Cummins,et al.  The Impulse Response Function and Ship Motion , 1962 .

[4]  Boualem Boashash,et al.  Estimating and interpreting the instantaneous frequency of a signal. II. A/lgorithms and applications , 1992, Proc. IEEE.

[5]  N. Huang,et al.  A study of the characteristics of white noise using the empirical mode decomposition method , 2004, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[6]  Torgeir Moan,et al.  A Comparison of Selected Strategies for Adaptive Control of Wave Energy Converters , 2011 .

[7]  John V. Ringwood,et al.  Energy-Maximizing Control of Wave-Energy Converters: The Development of Control System Technology to Optimize Their Operation , 2014, IEEE Control Systems.

[8]  N. Huang,et al.  The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis , 1998, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[9]  Norden E. Huang,et al.  Introduction to Hilbert-Huang Transform and Some Recent Developments , 2005 .

[10]  Torkel Bjarte-Larsson,et al.  Laboratory experiment on heaving body with hydraulic power take-off and latching control , 2006 .

[11]  Ronald W. Yeung,et al.  Nonlinear Model Predictive Control Applied to a Generic Ocean-Wave Energy Extractor , 2014 .

[12]  Jeffrey A. Oskamp,et al.  Power Calculations for a Passively Tuned Point Absorber Wave Energy Converter on the Oregon Coast , 2012 .

[13]  F. Fusco,et al.  A Simple and Effective Real-Time Controller for Wave Energy Converters , 2013, IEEE Transactions on Sustainable Energy.

[14]  Boualem Boashash,et al.  Estimating and interpreting the instantaneous frequency of a signal. I. Fundamentals , 1992, Proc. IEEE.

[15]  Paula B. Garcia-Rosa,et al.  Control-Informed Geometric Optimization of Wave Energy Converters: The Impact of Device Motion and Force Constraints , 2015 .

[16]  W. Cummins.  THE IMPULSE RESPONSE FUNCTION AND SHIP MOTIONS , 2010 .