Risk assessment for loader- and dozer-related fatal incidents in U.S. mining

The paper presents the results of research aimed at developing a risk assessment process that can be used to more thoroughly characterise risks associated with loader- and dozer-related fatal incidents in US mining. The assessment is based on historical data obtained from the US Mine Safety and Health Administration investigation reports, which includes 77 fatal incidents that occurred from 1995 to 2006. The Preliminary Hazard Assessment method is used in identifying and quantifying risks. Risk levels are then developed using a pre-established risk matrix that ranks them according to probability and severity. The resulting assigned risk value can then be used to prioritise risk control strategies. A total of 10 hazards were identified for loaders. The hazards ‘failure to follow adequate maintenance procedure’ and ‘failure of mechanical/electrical/hydraulic components’ were the most severe and frequent hazards and they fell into the category of ‘high’ risk. The same number of hazards was identified for dozers. The hazard ‘failure to identify adverse site/geological conditions’ was the most severe and frequent hazard and it fell into the category of ‘high’ risk.

[1]  Lynne M. Coventry,et al.  Human Factors , 2010, Handbook of Financial Cryptography and Security.

[2]  D Komljenovic,et al.  Analysis of fatalities and injuries involving mining equipment. , 2007, Journal of safety research.

[3]  Shin Ta Liu,et al.  Risk Modeling, Assessment, and Management , 1999, Technometrics.

[4]  Michael McCann.  Heavy equipment and truck-related deaths on excavation work sites. , 2006, Journal of safety research.

[5]  Vladislav Kecojevic,et al.  The causes and control of loader- and truck-related fatalities in surface mining operations , 2004, Injury control and safety promotion.

[6]  J P May.  ANALYSIS OF DUMP-POINT ACCIDENTS INVOLVING MOBILE MINING EQUIPMENT , 1990 .

[7]  Standards New Zealand.,et al.  Risk management guidelines: companion to AS/NZS 4360:2004 , 2004 .

[8]  Y. Haimes.  Risk Modeling, Assessment, and Management: Haimes/Risk Modeling, Assessment 2e , 2005 .

[9]  J. Joy.  Occupational safety risk management in Australian mining. , 2004, Occupational medicine.

[10]  Emery R. Hayhurst,et al.  Industrial Accident Prevention, A Scientific Approach , 1932 .

[11]  R. Kates,et al.  Comparative risk analysis of technological hazards (a review). , 1983, Proceedings of the National Academy of Sciences of the United States of America.

[12]  Robin Burgess-Limerick,et al.  Preventing Equipment Related Injuries In Underground U. S. Coal Mines , 1900 .

[13]  G. V. Kizil,et al.  The development and implementation of a minerals industry risk management gateway , 2005 .

[14]  Russell Levens.  A General Framework For Prioritizing Research To Reduce Injuries And Diseases in Mining , 1998 .

[15]  Dragan Komljenovic,et al.  An analysis of equipment-related fatal accidents in U.S. mining operations: 1995-2005 , 2007 .

[16]  Roger L. Brauer,et al.  Safety and health for engineers , 1990 .

[17]  Martin Helander,et al.  Safety of roof-bolting operations in underground coal mines , 1983 .

[18]  Dragan Komljenovic,et al.  Injuries in U.S. mining operations – A preliminary risk analysis , 2008 .

[19]  Ahmad Husseini,et al.  Canadian standards association , 1993 .

[20]  Robin Burgess-Limerick.  Reducing injury risks associated with underground coal mining equipment , 2005 .