Simulation study on the performance of solar/natural gas absorption cooling chillers

Abstract Solar radiation is a clean form of energy and solar cooling systems is one of the technologies which allow obtaining an important energy saving. Natural gas is a cheaper fuel than oil. It also burns cleaner than oil. Natural gas and renewable energy are complementary and in the future, the alignment of natural gas and renewable energy may be the most effective way to service the demand for clean energy. This paper presents a numerical study of solar/natural gas single effect lithium bromide absorption chillers. The development of this system is based on hot water chiller. As auxiliary power, fire from the natural gas burners is used to heat the hot water on its way to the generator. The overall performance of the absorption chiller system is analysed and discussed. For an evaporator temperature of 5 °C and when the condenser temperature is varied from 28 °C to 36 °C and generator temperatures is varied from 54 to 83 °C the maximum COP is 0.82 and the maximum exergetic efficiency is about 30%. For a given condenser temperature there is an optimum generator temperature for which the number of flat plate collectors is minimum. This optimum generator temperature corresponds to the generator temperature giving the maximum COP and exergy efficiency of the absorption cooling system. The solar/natural gas single effect lithium bromide absorption chillers, using solar energy as the energy source with only limited amount of gas as auxiliary power, not only reduces greatly the cost for electricity and operates in regions where there are abundant solar energy and cheap natural gas resources, but also compensates the peak-valley load difference and reduce CO 2 gas emissions. For a refrigeration capacity of 10 kW, the quantity of natural gas used to provide auxiliary load is very small and consequently the CO 2 gas emissions is very small (the maximum mass flow rate of CO 2 is less than 3 kg h −1 ).

[1]  Soteris A. Kalogirou,et al.  Solar thermal collectors and applications , 2004 .

[2]  Berhane H. Gebreslassie,et al.  A systematic tool for the minimization of the life cycle impact of solar assisted absorption cooling systems , 2010 .

[3]  Francis Agyenim,et al.  Design and experimental testing of the performance of an outdoor LiBr/H2O solar thermal absorption cooling system with a cold store , 2010 .

[4]  T. J. Kotas,et al.  The Exergy Method of Thermal Plant Analysis , 2012 .

[5]  Soteris A. Kalogirou,et al.  Exergy analysis of lithium bromide/water absorption systems , 2005 .

[6]  J. Pátek,et al.  A computationally effective formulation of the thermodynamic properties of LiBr-H2O solutions from 273 to 500 K over full composition range , 2006 .

[7]  F. Simon.  Flat-plate solar-collector performance evaluation with a solar simulator as a basis for collector selection and performance prediction , 1975 .

[8]  J. R. García Cascales,et al.  MODELLING AN ABSORPTION SYSTEM ASSISTED BY SOLAR ENERGY , 2011 .

[9]  T. M. Klucher.  Evaluation of models to predict insolation on tilted surfaces , 1978 .

[10]  Adnan Sözen,et al.  Effect of heat exchangers on performance of absorption refrigeration systems , 2001 .

[11]  Soteris A. Kalogirou,et al.  Simulation and optimization of a LiBr solar absorption cooling system with evacuated tube collectors , 2005 .

[12]  Rabah Gomri,et al.  Second law comparison of single effect and double effect vapour absorption refrigeration systems , 2009 .

[13]  J. Bugler.  The determination of hourly insolation on an inclined plane using a diffuse irradiance model based on hourly measured global horizontal insolation , 1977 .

[14]  M. J. Moran,et al.  Thermal design and optimization , 1995 .

[15]  Luis M. Serra,et al.  Monitoring and simulation of an existing solar powered absorption cooling system in Zaragoza (Spain) , 2011 .

[16]  Hamdy K. Elminir,et al.  Optimum solar flat-plate collector slope: Case study for Helwan, Egypt , 2006 .

[17]  Ernani Sartori,et al.  Convection coefficient equations for forced air flow over flat surfaces , 2006 .

[18]  Muhsin Kilic,et al.  Theoretical study on the effect of operating conditions on performance of absorption refrigeration system , 2007 .

[19]  Rabah Gomri,et al.  Investigation of the potential of application of single effect and multiple effect absorption cooling systems , 2010 .

[20]  J. Michalsky,et al.  Modeling daylight availability and irradiance components from direct and global irradiance , 1990 .

[21]  S. C. Mullick,et al.  Computation of glass-cover temperatures and top heat loss coefficient of flat-plate solar collectors with double glazing , 2007 .

[22]  Francesco Calise,et al.  Transient analysis and energy optimization of solar heating and cooling systems in various configurations , 2010 .

[23]  W. Beckman,et al.  Evaluation of hourly tilted surface radiation models , 1990 .

[24]  Umberto Desideri,et al.  Solar-powered cooling systems: Technical and economic analysis on industrial refrigeration and air-conditioning applications , 2009 .

[25]  M. Santamouris,et al.  On the calculation of solar utilizability for south oriented flat plate collectors tilted to an angle equal to the local latitude , 2006 .

[26]  Jaroslav Pátek,et al.  A simple formulation for thermodynamic properties of steam from 273 to 523 K, explicit in temperature and pressure , 2009 .