Improved determination of mechanical power output in rowing: Experimental results

ABSTRACT In rowing, mechanical power output is a key parameter for biophysical analyses and performance monitoring and should therefore be measured accurately. It is common practice to estimate on-water power output as the time average of the dot product of the moment of the handle force relative to the oar pin and the oar angular velocity. In a theoretical analysis we have recently shown that this measure differs from the true power output by an amount that equals the mean of the rower’s mass multiplied by the rower’s center of mass acceleration and the velocity of the boat. In this study we investigated the difference between a rower’s power output calculated using the common proxy and the true power output under different rowing conditions. Nine rowers participated in an on-water experiment consisting of 7 trials in a single scull. Stroke rate, technique and forces applied to the oar were varied. On average, rowers’ power output was underestimated with 12.3% when determined using the common proxy. Variations between rowers and rowing conditions were small (SD = 1.1%) and mostly due to differences in stroke rate. To analyze and monitor rowing performance accurately, a correction of the determination of rowers’ on-water power output is therefore required.

[1]  Vladimir M. Zatsiorsky,et al.  Mechanics and Biomechanics of Rowing: A Review , 1991 .

[2]  Vladimir M. Zatsiorsky,et al.  Kinetics of Human Motion , 2002 .

[3]  B. Sanderson,et al.  Towards optimizing rowing technique. , 1986, Medicine and science in sports and exercise.

[4]  P. Leva Adjustments to Zatsiorsky-Seluyanov's segment inertia parameters. , 1996 .

[5]  Mathijs J. Hofmijster,et al.  Effect of stroke rate on the distribution of net mechanical power in rowing , 2007, Journal of sports sciences.

[6]  Peter J Beek,et al.  Mechanical power output in rowing should not be determined from oar forces and oar motion alone , 2018, Journal of sports sciences.

[7]  A Baudouin,et al.  A biomechanical review of factors affecting rowing performance , 2002, British journal of sports medicine.

[8]  H. R. Kruk,et al.  An accurate estimation of the horizontal acceleration of a rower’s centre of mass using inertial sensors: a validation , 2018, European journal of sport science.

[9]  Ina Janssen,et al.  Validity and reliability of intra-stroke kayak velocity and acceleration using a GPS-based accelerometer , 2010, Sports biomechanics.

[10]  Mathijs J Hofmijster,et al.  Rowing skill affects power loss on a modified rowing ergometer. , 2008, Medicine and science in sports and exercise.

[11]  David Hawkins,et al.  Investigation of biomechanical factors affecting rowing performance. , 2004, Journal of biomechanics.

[12]  A. Lyttle,et al.  Comparison of force-related performance indicators between heavyweight and lightweight rowers , 2010, Sports biomechanics.

[13]  D. Roetenberg,et al.  Xsens MVN: Full 6DOF Human Motion Tracking Using Miniature Inertial Sensors , 2009 .

[14]  John Baker,et al.  Accuracy and reliability of GPS devices for measurement of movement patterns in confined spaces for court-based sports. , 2010, Journal of science and medicine in sport.

[15]  D. Lamb,et al.  A kinematic comparison of ergometer and on-water rowing , 1989, The American journal of sports medicine.

[16]  V Kleshnev,et al.  Boat acceleration, temporal structure of the stroke cycle, and effectiveness in rowing , 2010 .

[17]  Valery Kleshnev Estimation of Biomechanical Parameters and Propulsive Efficiency of Rowing , 2006 .

[18]  Aaron J. Coutts,et al.  Validity and reliability of GPS devices for measuring movement demands of team sports. , 2010, Journal of science and medicine in sport.