Correlation of actinic blank inspection and experimental phase defect printability on NXE3x00 EUV scanner

One challenge of extreme ultraviolet (EUV) mask defectivity is the severe printability of defects of the multi-layer (ML) mirror on the mask. These ML-defects are just nanometer high or deep local distortions of this ML mirror. Dedicated blank inspection tools have become available over time. One of them is the actinic blank inspection tool under development through EIDEC (Lasertec ABI). EIDEC and imec have jointly correlated its blank defect detection capability to wafers printed on ASML NXE3100 and NXE3300 scanners. Printing ML-defects were identified by wafer inspection, followed by subsequent repeater analysis, and correlated back to blank inspection. Forward correlation of ABI detections to the printed wafer was also successfully undertaken. The focus of this work has been on native defects. This paper will discuss the obtained results from the perspective of how to use ABI to assess which kind of native ML defects need to be avoided during blank fabrication.

[1]  Eric Hendrickx,et al.  Evidence of printing blank-related defects on EUV masks missed by blank inspection , 2011, European Mask and Lithography Conference.

[2]  Eric Hendrickx,et al.  Natural EUV mask blank defects: evidence, timely detection, analysis and outlook , 2010, Photomask Technology.

[3]  John Zimmerman,et al.  Progress on EUV pellicle development , 2014, Advanced Lithography.

[4]  Uwe Dietze,et al.  Integrated cleaning and handling automation of NXE3100 reticles , 2012, European Mask and Lithography Conference.

[5]  Noriaki Takagi,et al.  EUV scanner printability evaluation of natural blank defects detected by actinic blank inspection , 2015, Other Conferences.

[6]  Soichi Inoue,et al.  EUV actinic blank inspection tool with a high magnification review mode , 2012, Other Conferences.

[7]  T. Bret,et al.  Repair of natural EUV reticle defects , 2011, Photomask Technology.

[8]  Tsuyoshi Amano,et al.  Improvement of defect mitigation with EUV actinic blank inspection prototype for 16 nm hp , 2014, Advanced Lithography.

[9]  Tsuneo Terasawa,et al.  The capability of high magnification review function for EUV actinic blank inspection tool , 2013, Photomask and Next Generation Lithography Mask Technology.

[10]  Takeshi Yamane,et al.  Development of actinic full-field EUV mask blank inspection tool at MIRAI-Selete , 2009, Advanced Lithography.

[11]  E. Hendrickx,et al.  Towards reduced impact of EUV mask defectivity on wafer , 2014, Photomask and Next Generation Lithography Mask Technology.

[12]  Andrew Cross,et al.  Investigation of the performance of state-of-the-art defect inspection tools within EUV lithography , 2012, Advanced Lithography.

[13]  Eric Hendrickx,et al.  Additional evidence of EUV blank defects first seen by wafer printing , 2011, Photomask Technology.