Heat assisted magnetic recording with a fully integrated recording head

Scaling the areal density, while maintaining a proper balance between media signal-to-noise, thermal stability and writability will soon require an alternative recording technology. Heat Assisted Magnetic Recording (HAMR) can achieve this balance by allowing high anisotropy media to be written by heating the media during the writing process (e.g. by laser light) to temporarily lower the anisotropy. Three major challenges of designing a HAMR head that tightly focuses light and collocates it with the magnetic field are discussed: 1) Magnetic Field Delivery, 2)Optical Delivery, and 3) Integration of Magnetic & Optical Field Delivery Components. Thousands of these HAMR heads were built into sliders and HGAs, and optical and scanning electron micrograph images are shown. Scanning near-field optical microscopy (SNOM) characterization of the HAMR head shows that the predicted ~λ/4 full-width half-maximum (FWHM) spot size can be achieved using 488 nm light (124 nm was achieved). SNOM images also show that wafer level fabricated apertures were able to effectively eliminate sidelobes from the focused spot intensity profile. An MFM image of HAMR media shows that Non-HAMR (laser power off) was not able to write transitions in the HAMR specific media even at very high write currents, but transitions could be written using HAMR (laser power on), even at lower write currents. A cross-track profile is shown for a fully integrated HAMR head where the magnetic pole physical width is ~350 nm, but the written track is ~200nm, which demonstrates HAMR. A HAMR optimization contour shows that there is an optimum write current and laser power and that simply going to the highest write current and laser power does not lead to the best recording. Lastly, some prospects for advancing HAMR are given and a few key problems to be solved are mentioned.

[1]  Tim Rausch,et al.  Near Field Heat Assisted Magnetic Recording with a Planar Solid Immersion Lens , 2006 .

[2]  Christophe Mihalcea,et al.  Miniature planar solid immersion mirror with focused spot less than a quarter wavelength. , 2005, Optics express.

[3]  Michael F. Toney,et al.  Temperature dependent magnetic properties of highly chemically ordered Fe55−xNixPt45L10 films , 2002 .

[4]  U. Welp,et al.  Surface plasmons at single nanoholes in Au films , 2004 .

[5]  Hervé Rigneault,et al.  Surface plasmon excitation on a single subwavelength hole in a metallic sheet. , 2005, Applied optics.

[6]  Tim Rausch,et al.  Spin stand characterization of dielectric optical waveguides fabricated on AlTiC sliders for heat-assisted magnetic recording , 2004, Optical Data Storage.

[7]  S. Bukofsky,et al.  Application of near-field optics to critical dimension metrology , 1996, Conference Proceedings LEOS'96 9th Annual Meeting IEEE Lasers and Electro-Optics Society.

[8]  T Matsumoto,et al.  Writing 40 nm marks by using a beaked metallic plate near-field optical probe. , 2006, Optics letters.

[9]  Christophe Mihalcea,et al.  Near-field optical recording using a planar solid immersion mirror , 2005 .

[10]  Tim Rausch,et al.  Fabrication of dielectric optical waveguides on AlTiC sliders for heat-assisted magnetic recording , 2004, Optical Data Storage.

[11]  P. Yeh,et al.  Optical Waves in Layered Media , 1988 .

[12]  M. Fatih Erden,et al.  Heat Assisted Magnetic Recording , 2008, Proceedings of the IEEE.