Withdrawal: Selection of Parameters for Numerical Models of the Working Process of Axial Uncooled Turbines Intended to Perform Optimization and Verification Calculations

[1]  Igor N. Egorov,et al.  IMPROVEMENT OF THE GAS-TURBINE ENGINE COMPRESSOR USING MODERN CFD TECHNIQUE AND "IOSO NM" OPTIMIZATION SOFTWARE , 2006 .

[2]  Wei Zhao,et al.  Aerodynamic Design and Analysis of a Multistage Vaneless Counter-Rotating Turbine , 2014 .

[3]  Stephan Staudacher,et al.  Numerical Study of Reynolds Number Effects of Cavity Volumes and Seal Gaps on LP Turbine Performance , 2012 .

[4]  Shahrokh Shahpar,et al.  Aerodynamic Optimisation of High Pressure Turbines for Lean-Burn Combustion System , 2012 .

[5]  John D. Denton,et al.  A Numerical Investigation Into the Sources of Endwall Loss in Axial Flow Turbines , 2012 .

[6]  Jonathan Ong,et al.  Loss Audit of a Turbine Stage , 2015 .

[7]  Jonathan Ong,et al.  A Study of Trailing-Edge Losses in Organic Rankine Cycle Turbines , 2015 .

[8]  Vladimir Vassiliev,et al.  Effect of Unguided Turning Angle and Trailing Edge Shape on Cooled Blade Loss , 2014 .

[9]  Valery Chernoray,et al.  Experimental and Numerical Investigation of an Aerodynamically Loaded Guide Vane in a Turbine Duct , 2011 .

[10]  Scott Carson,et al.  Design and Test Results of a Ultra High Loaded Single Stage High Pressure Turbine , 2013 .

[11]  Ping Wang,et al.  Research of a New Design Method of Variable Area Nozzle Turbine for VCE: Harmonic Design Method , 2011 .

[12]  Grigorii Popov,et al.  Workflow Optimization of Multistage Axial Turbine , 2015 .

[13]  Wei Jia,et al.  Numerical Investigation of the Interaction Between Upstream Purge Flow and Mainstream in a Highly-Loaded Turbine , 2014 .

[14]  Hany Moustapha,et al.  Rapid airfoil design for uncooled high pressure turbine blades , 2015 .

[15]  Bo Liu,et al.  Numerical Investigation of Non-Axisymmetric Endwalls in a High Pressure Axial Flow Turbine , 2015 .

[16]  Santosh Abraham,et al.  Effect of Turbine Airfoil Shape on Aerodynamic Losses for Turbine Airfoils Operating Under Transonic Conditions , 2011 .

[17]  Roque Corral,et al.  Interaction of Rim Seal and Main Annulus Flow in a Low-Speed Turbine Rig , 2013 .

[18]  Michel van Rooij,et al.  Engine Performance Prediction for Varied LPT Vane Geometry Utilizing Test Rig Data and Combined CFD and Cycle Models , 2012 .

[19]  Paul F. Beard,et al.  Impact of Severe Temperature Distortion on Turbine Efficiency , 2011 .

[20]  Qun Zheng,et al.  Variable Geometry Design of a High Endwall Angle Power Turbine for Marine Gas Turbines , 2015 .

[21]  Matthew Montgomery,et al.  Turbine Hub and Shroud Sealing Flow Loss Mechanisms , 2011 .

[22]  Peter Jeschke,et al.  Investigation of Non-Axisymmetric Endwall Contouring and 3D Airfoil Design in a 1.5 Stage Axial Turbine: Part I — Design and Novel Numerical Analysis Method , 2014 .

[23]  Joerg R. Seume,et al.  Aerodynamic Effects of Non-Uniform Surface Roughness on a Turbine Blade , 2013 .

[24]  Steen A. Sjolander,et al.  Effects of Simplified Platform Overlap and Cavity Geometry on the Endwall Flow: Measurements and Computations in a Low-Speed Linear Turbine Cascade , 2013 .

[25]  Qingjun Zhao,et al.  Investigation on the Reduction of Trailing Edge Shock Losses for a Highly Loaded Transonic Turbine , 2016 .

[26]  Santosh Abraham,et al.  Investigation of Effect of End Wall Contouring Methods on a Transonic Turbine Blade Passage , 2011 .

[27]  Magnus Genrup,et al.  Vortexing Methods to Reduce Secondary Losses in a Low Reaction Industrial Turbine , 2015 .

[28]  Shinichi Higuchi,et al.  Improving the Performance of a High Pressure Gas Turbine Stage Using a Profiled Endwall , 2013 .

[29]  Theodosios Korakianitis,et al.  Tip Leakage Losses in Subsonic and Transonic Blade-Rows , 2011 .

[30]  Glen C Snedden,et al.  Optimization of Non-Axisymmetric End Wall Contours for the Rotor of a Low Speed, 1 1/2 Stage Research Turbine With Unshrouded Blades , 2012 .

[31]  Dong-Ho Lee,et al.  Optimization Framework Using Surrogate Model for Aerodynamically Improved 3D Turbine Blade Design , 2014 .

[32]  Reza S. Abhari,et al.  A Low Pressure Turbine With Profiled End Walls and Purge Flow Operating With a Pressure Side Bubble , 2011 .

[33]  Masato Furukawa,et al.  Suppression of Secondary Flows in an Axial Flow Turbine Rotor With a Novel Blade Design Concept , 2014 .

[34]  Stephan Staudacher,et al.  On the Assessment of Turbine Efficiency From Experimental Data for Low Pressure Turbines at Low Reynolds Numbers , 2012 .

[35]  Ingo Roehle,et al.  Numerical Study of Incidence Angles and Gap Heights in Turbine Cascades and Rotors on Tip Clearance Losses , 2013 .

[36]  P. Adami,et al.  Analysis of Radial Migration of Hot-Streak in Swirling Flow Through HP Turbine Stage , 2012 .

[37]  Eduardo Romero,et al.  Effect of NGV Lean Under Influence of Inlet Temperature Traverse , 2013 .

[38]  Huimin Tang,et al.  Unsteady Effects of Profiled Endwalls on a 1.5 Stage Axial Turbine , 2015 .

[39]  Hualing Luo,et al.  Endwall Contouring Optimization in a High Pressure Turbine Vane With Consideration of Rim Seal Flow , 2014 .

[40]  Peter Jeschke,et al.  Numerical Analysis of Three-Dimensional Turbine Airfoil Designs , 2011 .

[41]  Joerg R. Seume,et al.  Time-Resolved Numerical Study of Axial Gap Effects on Labyrinth-Seal Leakage and Secondary Flow in a LP Turbine , 2013 .

[42]  Davide Lengani,et al.  Aerodynamic Effects of an unshrouded Low Pressure Turbine on a low Aspect Ratio Exit Guide Vane , 2012 .

[43]  Cengiz Camci,et al.  Computational Validation of the Flow Through a Turbine Stage and the Effects of Rim Seal Cavity Leakage on Secondary Flows , 2012 .

[44]  Inga Mahle,et al.  Inverse Fin Arrangement in a Low Pressure Turbine to Improve the Interaction Between Shroud Leakage Flows and Main Flow , 2011 .

[45]  Stephan Staudacher,et al.  LP Turbine Secondary Vortices: Reynolds Lapse , 2011 .

[46]  Gabriele D'Ippolito,et al.  The Influence of Blade Sweep Technique in Linear Cascade Configuration , 2011 .

[47]  Bhaskar Roy,et al.  Investigation of Turbine Cascade Blades With Part-Span Sweep With an Open End , 2013 .

[48]  Cengiz Camci,et al.  Influence of Leading Edge Fillet and Nonaxisymmetric Contoured Endwall on Turbine NGV Exit Flow Structure and Interactions With the Rim Seal Flow , 2013 .

[49]  Filippo Rubechini,et al.  Analysis of a LPT Rotor Blade For a Geared Engine. Part I: Aero-Mechanical Design and Validation. , 2016 .

[50]  F. Taremi,et al.  Application of Endwall Contouring to Transonic Turbine Cascades: Experimental Measurements at Design Conditions , 2011 .

[51]  Huimin Tang,et al.  Design Optimization of Profiled Endwall in a High Work Turbine , 2014 .

[52]  Howard Hodson,et al.  Unsteady Interaction Between Annulus and Turbine Rim Seal Flows , 2012 .

[53]  Li He,et al.  Rotor Blade Heat Transfer Characteristics for High Pressure Turbine Stage Under Inlet Temperature and Velocity Traverses , 2014 .

[54]  Andreas Marn,et al.  Impact of Passive Tip-Injection on Tip-Leakage Flow in Axial Low Pressure Turbine Stage , 2015 .

[55]  Siegfried Sumser,et al.  Innovative Variable Turbine Concept for Turbochargers , 2011 .

[56]  Sooyoung Park,et al.  Design of an Air-Starter Turbine and Starting Performance Prediction Through the Numerical Analysis , 2015 .

[57]  Meinhard T. Schobeiri,et al.  Aerodynamic Investigation of the Performance of a Two Stage Axial Turbine at Design and Off-Design Conditions , 2011 .

[58]  Karen A. Thole,et al.  Flowfield Measurements in a Single Row of Low Aspect Ratio Pin-Fins , 2012 .

[59]  Friedrich Kost,et al.  Design and Test of a Highly Loaded Single-Stage High Pressure Turbine , 2011 .

[60]  Qun Zheng,et al.  Viscous Controlled Vortex Design of a 1.5-Stage Axial Subsonic Test Turbine , 2011 .

[61]  Marcus Meyer,et al.  CAD-Based Adjoint Shape Optimisation of a One-Stage Turbine With Geometric Constraints , 2015 .