A ratio metric analog-to-digital converter for eddy current displacement sensors

Displacement sensors are widely employed in industry for measuring position and movement of objects as well as for measuring other physical quantities like pressure, acceleration, etc., which can first be converted into movement. This thesis describes the implementation of a ratio metric analog-to-digital converter (ADC) for an eddy current displacement sensor interface. The interface which has been implemented by Dr. Nabavi as a PhD project, consists of a low-power front-end oscillator and a synchronous demodulator. An excitation frequency of 20 MHz enables the accurate sensing of targets with only a few tens of ?m thick conductive surfaces. The ADC sampling frequency is 1.25 MHz, which provides an over-sampling ratio (OSR) of 312. The sampling frequency is obtained from the excitation frequency, which synchronizes the ADC and the interface. A ratio-metric measurement approach is applied to suppress the oscillator's noise contribution. The ratio-metric ADC has been realized in a 0.35?m BiCMOS technology and consumes 1.8mW. Measurement results demonstrate a total harmonic distortion of about -85dB, and a resolution of 16 bits within 1 kHz signal bandwidth.

[1]  Hao-Chiao Hong,et al.  A 65-fJ/Conversion-Step 0.9-V 200-kS/s Rail-to-Rail 8-bit Successive Approximation ADC , 2007, IEEE Journal of Solid-State Circuits.

[2]  I. Galton,et al.  A 12 mW ADC delta-sigma modulator with 80 dB of dynamic range integrated in a single-chip Bluetooth transceiver , 2001, Proceedings of the IEEE 2001 Custom Integrated Circuits Conference (Cat. No.01CH37169).

[3]  Bingxue Shi,et al.  A high speed/power ratio continuous-time CMOS current comparator , 2000, ICECS 2000. 7th IEEE International Conference on Electronics, Circuits and Systems (Cat. No.00EX445).

[4]  Lucien Breems,et al.  Continuous-Time Sigma-Delta Modulation for IF A/D Conversion in Radio Receivers , 2001 .

[5]  Heemin Y. Yang.  A time-based energy-efficient analog-to-digital converter , 2005, IEEE Journal of Solid-State Circuits.

[6]  Behzad Razavi,et al.  Design of Analog CMOS Integrated Circuits , 1999 .

[7]  Rudy Van De Plassche.  Integrated analog-to-digital and digital-to-analog converters / Rudy Van De Plassche , 1994 .

[8]  John Choma,et al.  A Continuous-Time Switched-Current $\Sigma\Delta$ Modulator with Reduced Loop Delay , 1998 .

[9]  M. R. Nabavi.  Low-power high-performance integrated interface for eddy-current displacement sensors , 2011 .

[10]  Johan H. Huijsing,et al.  Precision Temperature Sensors in CMOS Technology , 2006 .

[11]  Stoyan N. Nihtianov,et al.  Design of reliable interface system for eddy current displacement sensors in vacuum environments1 , 2008, 2008 IEEE International Symposium on Circuits and Systems.

[12]  John Choma,et al.  A continuous-time common-mode feedback circuit (CMFB) for high-impedance current-mode applications , 2000 .

[13]  Horst Zimmermann,et al.  Continuous-Time Common-Mode Feedback Circuit for Applications with Large Output Swing and High Output Impedance , 2008, 2008 11th IEEE Workshop on Design and Diagnostics of Electronic Circuits and Systems.

[14]  Yuqing Yang,et al.  A 114-dB 68-mW Chopper-stabilized stereo multibit audio ADC in 5.62 mm/sup 2/ , 2003 .

[15]  Torsten Lehmann,et al.  Integrating data converters for picoampere currents from electrochemical transducers , 2000, 2000 IEEE International Symposium on Circuits and Systems. Emerging Technologies for the 21st Century. Proceedings (IEEE Cat No.00CH36353).

[16]  Johan H. Huijsing,et al.  High-resolution IF-to-baseband ΣΔ ADC for car radios , 2008 .

[17]  David A. Johns,et al.  Analog Integrated Circuit Design , 1996 .

[18]  Gabor C. Temes,et al.  Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilization , 1996, Proc. IEEE.

[19]  Michiel A. P. Pertijs,et al.  An interface for eddy current displacement sensors with 15-bit resolution and 20 MHz excitation , 2010, 2010 Proceedings of ESSCIRC.

[20]  Kenneth W. Martin,et al.  High-order multibit modulators and pseudo data-weighted-averaging in low-oversampling ΔΣ ADCs for broad-band applications , 2004, IEEE Trans. Circuits Syst. I Regul. Pap..

[21]  Colin D. Simpson,et al.  Industrial Electronics , 1936, Nature.

[22]  Bharadwaj S. Amrutur,et al.  Continuous Time Sigma Delta Modulator Employing a Novel Comparator Architecture , 2007, 20th International Conference on VLSI Design held jointly with 6th International Conference on Embedded Systems (VLSID'07).

[23]  Stoyan N. Nihtianov,et al.  Eddy-Current Sensor Interface for Advanced Industrial Applications , 2011, IEEE Transactions on Industrial Electronics.

[24]  John Choma,et al.  A continuous-time common-mode feedback circuit (CMFB) for high-impedance current mode application , 1998, 1998 IEEE International Conference on Electronics, Circuits and Systems. Surfing the Waves of Science and Technology (Cat. No.98EX196).

[25]  Gabor C. Temes,et al.  Understanding Delta-Sigma Data Converters , 2004 .

[26]  K. Nguyen,et al.  A 106dB SNR hybrid oversampling ADC for digital audio , 2005, ISSCC. 2005 IEEE International Digest of Technical Papers. Solid-State Circuits Conference, 2005..

[27]  Shouli Yan,et al.  A 2.7mW 2MHz Continuous-Time ΣΔ Modulator with a Hybrid Active-Passive Loop Filter , 2006, IEEE Custom Integrated Circuits Conference 2006.