Experimental evaluation of an integrated electric vehicle AC/HP system operating with R134a and R407C

Abstract An integrated air conditioning/heat pump (AC/HP) system for electric vehicle (EV) was developed and the system heating performances under low temperature were quantitatively evaluated. The AC/HP system employed electric scroll compressor to achieve high compressor speed. The heat exchangers were derived from the original EV air conditioning system. A four-way reversing valve was used to switch the system working modes between AC and HP. Heating tests using R134a and R407C as refrigerants were conducted respectively in an environmental chamber. The cabin temperature, the compressor power and other variables were analyzed to evaluate the system heating capability and energy efficiency. Test results showed that the AC/HP system satisfied the EV cabin heating requirement at the ambient temperature −10 °C. It reduced the EV power consumption remarkably compared to the original PTC heater. But the system performance was greatly affected by the ambient temperature. Compared to R134a, the system heating capability and the compressor power of R407C were increased but the energy efficiency was reduced. Increasing the compressor speed could limitedly improve the heating capacity, especially at the decreased ambient temperature. But it would reduce the energy efficiency distinctly. Test results also implied that the system performance has the potential for improvement.

[1]  J. Yoo,et al.  Performance analysis and simulation of automobile air conditioning system , 2000 .

[2]  Cong-Toan Tran,et al.  In situ measurement methods of air to air heat pump performance , 2013 .

[3]  Yen-Hung Chen,et al.  Control of air-conditioning systems in heating mode to enhance transient performance and steady-state efficiency , 2009 .

[4]  Thomas H. Bradley,et al.  Estimating the HVAC energy consumption of plug-in electric vehicles , 2014 .

[5]  Huiming Zou,et al.  Experimental investigation on heating performance of heat pump for electric vehicles at −20 °C ambient temperature , 2015 .

[6]  Cong-Toan Tran,et al.  On-field measurement method of vapor injection heat pump system , 2014 .

[7]  Zhaogang Qi,et al.  Advances on air conditioning and heat pump system in electric vehicles – A review , 2014 .

[8]  Wenming Yang,et al.  Advances in heat pump systems: A review , 2010 .

[9]  T.-J. Yeh,et al.  Modeling, identification and control of air-conditioning systems , 2007 .

[10]  Xinkai Wu,et al.  Electric vehicles’ energy consumption measurement and estimation , 2015 .

[11]  T. S. Ravikumar,et al.  On-road performance analysis of R134a/R600a/R290 refrigerant mixture in an automobile air-conditioning system with mineral oil as lubricant , 2009 .

[12]  J. Jabardo,et al.  Modeling and experimental evaluation of an automotive air conditioning system with a variable capacity compressor , 2002 .

[13]  M. Hosoz,et al.  Performance evaluation of an integrated automotive air conditioning and heat pump system , 2006 .

[14]  Baomin Dai,et al.  Thermodynamic perfectibility based analysis of energy-efficiency standards for air conditioning prod , 2011 .

[15]  Hanqing Wang,et al.  Performance comparison of air source heat pump with R407C and R22 under frosting and defrosting , 2008 .

[16]  Jong-Phil Won,et al.  Performance characteristics of mobile heat pump for a large passenger electric vehicle , 2013 .

[17]  K. Y. Kim,et al.  Experimental studies on the heating performance of the PTC heater and heat pump combined system in fuel cells and electric vehicles , 2012 .

[18]  Eric Winandy,et al.  Refrigerant and Scroll Compressor Options for Best Performance of Various European Heat Pump Configurations , 2008 .

[19]  Xudong Wang.  PERFORMANCE INVESTIGATION OF TWO-STAGE HEAT PUMP SYSTEM WITH VAPOR-INJECTED SCROLL COMPRESSOR , 2008 .

[20]  Robert J. Moffat,et al.  Describing the Uncertainties in Experimental Results , 1988 .