Earth fault distance protection with distance protection relays is common practice in solidly grounded networks. However, in compensated networks earth faults can cause big problems, because they do not extinguish themselves. To find the fault point is from high interest also in combination with network expansion. In previous investigations the authors found that the classic algorithm of these distance protection relays principally can be used also for compensated networks, - however the accuracy of the distance calculation strongly depends on the network conditions. In this paper a new improved algorithm is developed. The simulations show, that this improved distance calculation provides very good accuracy up to earth fault transitions impedances of 1 kohm. Furtheron it is shown in the paper that the same algorithm can be used in 2-phase networks as well. With the implemented improvements the algorithm again allows earth fault transitions impedances of up to 1 kohm. Finally, the simulation results are validated by real test data to verify the usability of this improved algorithm.
[1]
Lothar Fickert,et al.
Impedanzmessungen an Leitungen
,
2007,
Elektrotech. Informationstechnik.
[2]
Matti Lehtonen,et al.
TRANSIENT BASED EARTH FAULT LOCATION IN 110 KV SUBTRANSMISSION NETWORKS
,
2005
.
[3]
C. L. Fortescue,et al.
Method of symmetrical co-ordinates applied to the solution of polyphase networks
,
1918,
Proceedings of the American Institute of Electrical Engineers.
[4]
Matti Lehtonen,et al.
Earth fault distance computation with fundamental frequency signals based on measurements in substation supply bay
,
2002
.
[5]
Lothar Fickert,et al.
INNOVATIVE NEUTRAL POINT TREATMENT IN COMPENSATED NETWORKS
,
2007
.
[6]
Georg Achleitner,et al.
VERFAHREN ZUR ENTFERNUNGSORTUNG VON ERDSCHLÜSSEN
,
2007
.