A Novel Power Injection Model of IPFC for Power Flow Analysis Inclusive of Practical Constraints

This paper describes a novel power injection model (PIM) of interline power flow controller (IPFC) for power flow analysis. In this model, the impedance of the series coupling transformer and the line charging susceptance are all included. In this situation, it is proved that the original structure and symmetry of the admittance matrix can still be kept, and thus, the Jacobian matrix can keep the block-diagonal properties, and sparsity technique can be applied. The IPFC state variables are adjusted simultaneously with the network state variables in order to achieve the specified control targets. Furthermore, the model can take into account the practical constraints of IPFC in Newton power flow. Numerical results based on the IEEE 57-bus and IEEE 300-bus systems are used to demonstrate the effectiveness and performance of the IPFC model

[1]  Y. Homma,et al.  Dependence of electromigration lifetime on the square of current density , 1993, 31st Annual Proceedings Reliability Physics 1993.

[2]  R. J. Nelson,et al.  A study of equipment sizes and constraints for a unified power flow controller , 1996, Proceedings of 1996 Transmission and Distribution Conference and Exposition.

[3]  Laszlo Gyugyi,et al.  AEP unified power flow controller performance , 1999 .

[4]  K. Maeguchi,et al.  A threshold pulse width for electromigration under pulsed stress conditions , 1989, Proceedings., Sixth International IEEE VLSI Multilevel Interconnection Conference.

[5]  Hua Ye,et al.  A thermodynamic model for electrical current induced damage , 2003, 2004 Proceedings. 54th Electronic Components and Technology Conference (IEEE Cat. No.04CH37546).

[6]  Aristos Christou,et al.  Failure mechanism models for electromigration , 1994 .

[7]  Xiao-Ping Zhang,et al.  Modelling of the interline power flow controller and the generalised unified power flow controller in Newton power flow , 2003 .

[8]  M. R. Iravani,et al.  Steady-state and dynamic models of unified power flow controller (UPFC) for power system studies , 1996 .

[9]  S. Molokov,et al.  The fragmentation of wires due to pulsed currents: influence of the skin effect , 2000 .

[10]  J.H. Chow,et al.  A common modeling framework of voltage-sourced converters for load flow, sensitivity, and dispatch analysis , 2004, IEEE Transactions on Power Systems.

[11]  C. Fuerte-Esquivel,et al.  Incorporation of a UPFC model in an optimal power flow using Newton's method , 1998 .

[12]  J. W. Haslett,et al.  Simulation of Temperature Cycling Effects on Electromigration Behavior Under Pulsed Current Stress , 1998 .

[13]  Bruce Fardanesh,et al.  Convertible static compensator project-hardware overview , 2000, 2000 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.00CH37077).

[14]  K. K. Sen.  SSSC-static synchronous series compensator: theory, modeling, and application , 1998 .

[15]  Xiao-Ping Zhang,et al.  Advanced modeling of the multicontrol functional static synchronous series compensator (SSSC) in Newton power flow , 2003 .

[16]  Enrique Acha,et al.  A comprehensive Newton-Raphson UPFC model for the quadratic power flow solution of practical power networks , 2000 .

[17]  K. K. Sen,et al.  STATCOM-STATic synchronous COMpensator: theory, modeling, and applications , 1999, IEEE Power Engineering Society. 1999 Winter Meeting (Cat. No.99CH36233).

[18]  Yong-Hua Song,et al.  Strategies for handling UPFC constraints in steady-state power flow and voltage control , 2000 .

[19]  Chenming Hu,et al.  Modeling electromigration lifetime under bidirectional current stress , 1995, IEEE Electron Device Letters.

[20]  Laszlo Gyugyi,et al.  AEP UPFC project: installation, commissioning and operation of the /spl plusmn/160 MVA STATCOM (phase I) , 1998 .

[21]  Mehrdad Ghandhari,et al.  Use of UPFC for optimal power flow control , 1997 .

[22]  Laszlo Gyugyi,et al.  Operation of the unified power flow controller (UPFC) under practical constraints , 1998 .

[23]  M. Sakimoto,et al.  Temperature measurement of Al metallization and the study of Black's model in high current density , 1995, Proceedings of 1995 IEEE International Reliability Physics Symposium.

[24]  G.E. Leyh.  A critical analysis of IGBT geometries, with the intention of mitigating undesirable destruction by fault scenarios of an adverse nature , 2003, Digest of Technical Papers. PPC-2003. 14th IEEE International Pulsed Power Conference (IEEE Cat. No.03CH37472).

[25]  S. J. Krumbein,et al.  Metallic electromigration phenomena , 1988 .

[26]  Joe H. Chow,et al.  A common modeling framework of voltage-sourced converters for loadflow, sensitivity, and dispatch analysis , 2003, 2003 IEEE Power Engineering Society General Meeting (IEEE Cat. No.03CH37491).

[27]  K. Nielsen,et al.  Atlas current connection tests performed on Pegasus II , 1999, Digest of Technical Papers. 12th IEEE International Pulsed Power Conference. (Cat. No.99CH36358).

[28]  S. Molokov,et al.  Why high pulsed currents shatter metal wires? , 2001, PPPS-2001 Pulsed Power Plasma Science 2001. 28th IEEE International Conference on Plasma Science and 13th IEEE International Pulsed Power Conference. Digest of Papers (Cat. No.01CH37251).

[29]  K. K. Sen,et al.  The interline power flow controller concept: a new approach to power flow management in transmission systems , 1999 .

[30]  Y. Z. Sun,et al.  Power Flow Control Approach to Power Systems with Embedded Facts Devices , 2002, IEEE Power Engineering Review.

[31]  E. J. Stacey,et al.  UPFC-unified power flow controller: theory, modeling, and applications , 1998 .

[32]  Sergio Bruno,et al.  Unified power flow controllers for security-constrained transmission management , 2004 .

[33]  M. Ghandhari,et al.  Control Lyapunov Functions for Controllable Series Devices , 2001, IEEE Power Engineering Review.

[34]  E. Blackmore,et al.  Analysis of high-power IGBT short circuit failures , 2004, IEEE Transactions on Plasma Science.

[35]  G. T. Heydt,et al.  Power flow control and power flow studies for systems with FACTS devices , 1998 .