Ionic Conductivity of PEMFC Electrodes Effect of Nafion Loading

The effect of Nafion loading in the cathode catalyst layer of proton exchange membrane fuel cell (PEMFC) electrodes was studied by impedance spectroscopy, cyclic voltammetry, and polarization experiments. Catalyst utilization. determined by cyclic voltammetry, peaked at 76% for a Nafion loading of ca. 30 mass %, and this coincides with the optimum performance obtained in H 2 /O 2 fuel cells. However, the small range of utilizations observed (55-76%) cannot explain the wide range of performances. The impedance results show that the ionic conductivity of the cathode increased greatly with increasing Nafion content, and this is the main factor responsible for the increase in performance up to 30% Nafion. The loss of performance at higher Nafion loadings must have been due to an increasing oxygen transport resistance, because the electronic resistance did not increase significantly. In fact, the highest electronic resistances were observed at low Nafion loadings, indicating that Nafion played a significant role as a binder.

[1]  Fernando H. Garzon,et al.  Determination of Ionic and Electronic Resistivities in Carbon/Polyelectrolyte Fuel-Cell Composite Electrodes , 2002 .

[2]  Y. Bultel,et al.  Modeling impedance diagrams of active layers in gas diffusion electrodes: diffusion, ohmic drop effects and multistep reactions , 2002 .

[3]  B. Andreaus,et al.  Analysis of performance losses in polymer electrolyte fuel cells at high current densities by impedance spectroscopy , 2002 .

[4]  G. Lindbergh,et al.  Investigation of Mass-Transport Limitations in the Solid Polymer Fuel Cell Cathode I. Mathematical Model , 2002 .

[5]  M. De Francesco,et al.  Comparison of high surface Pt/C catalysts by cyclic voltammetry , 2002 .

[6]  A. Shukla,et al.  Effect of Diffusion-Layer Morphology on the Performance of Solid-Polymer-Electrolyte Direct Methanol Fuel Cells , 2002 .

[7]  G. Acres,et al.  Recent advances in fuel cell technology and its applications , 2001 .

[8]  P. Pickup,et al.  Simulation and analysis of the impedance behaviour of electroactive layers with non-uniform conductivity and capacitance profiles , 2001 .

[9]  P. Pickup,et al.  Modification of carbon supported catalysts to improve performance in gas diffusion electrodes , 2001 .

[10]  P. Pickup,et al.  Chemical Modification of Proton Exchange Membrane Fuel Cell Catalysts with a Sulfonated Silane , 2001 .

[11]  E. Gonzalez,et al.  Effect of membrane characteristics and humidification conditions on the impedance response of polymer electrolyte fuel cells , 2001 .

[12]  J. Kerres.  Development of ionomer membranes for fuel cells , 2001 .

[13]  Mariana Ciureanu and,et al.  Electrochemical Impedance Study of PEM Fuel Cells. Experimental Diagnostics and Modeling of Air Cathodes , 2001 .

[14]  Yann Bultel,et al.  Oxygen reduction reaction kinetics and mechanism on platinum nanoparticles inside Nafion , 2001 .

[15]  J. Song,et al.  Optimal composition of polymer electrolyte fuel cell electrodes determined by the AC impedance method , 2001 .

[16]  L. Carrette,et al.  Fuel cells: principles, types, fuels, and applications. , 2000, Chemphyschem : a European journal of chemical physics and physical chemistry.

[17]  Y. Bultel,et al.  Concentration and potential distributions in the active layer of proton exchange membrane fuel cell electrodes , 2000 .

[18]  P. Pickup,et al.  Characterization of polymer supported catalysts by cyclic voltammetry and rotating disk voltammetry , 2000 .

[19]  Y. Bultel,et al.  Catalyst gradient for cathode active layer of proton exchange membrane fuel cell , 2000 .

[20]  A. J. Appleby,et al.  Design equations for optimized PEM fuel cell electrodes , 2000 .

[21]  S. Cha,et al.  Performance of Proton Exchange Membrane Fuel Cell Electrodes Prepared by Direct Deposition of Ultrathin Platinum on the Membrane Surface , 1999 .

[22]  A. Kornyshev,et al.  Electrochemical impedance of the cathode catalyst layer in polymer electrolyte fuel cells , 1999 .

[23]  P. Pickup,et al.  CHARACTERIZATION OF IONIC CONDUCTIVITY PROFILES WITHIN PROTON EXCHANGE MEMBRANE FUEL CELL GAS DIFFUSION ELECTRODES BY IMPEDANCE SPECTROSCOPY , 1999 .

[24]  G. Squadrito,et al.  Improvement in the diffusion characteristics of low Pt-loaded electrodes for PEFCs , 1999 .

[25]  T. Springer,et al.  Modelistic interpretation of the power response of a polymer electrolyte fuel cell , 1998 .

[26]  Sanjeev Mukerjee,et al.  Effects of Nafion impregnation on performances of PEMFC electrodes , 1998 .

[27]  S. Srinivasan,et al.  Measurements of proton conductivity in the active layer of PEM fuel cell gas diffusion electrodes , 1998 .

[28]  Yann Bultel,et al.  Electrocatalysis, diffusion and ohmic drop in PEMFC: Particle size and spatial discrete distribution effects , 1998 .

[29]  G. Squadrito,et al.  Influence of the structure in low-Pt loading electrodes for polymer electrolyte fuel cells , 1998 .

[30]  Y. Bultel,et al.  Modelling the mode of operation of PEMFC electrodes at the particle level: influence of ohmic drop within the active layer on electrode performance , 1998 .

[31]  Jürgen Fleig,et al.  The Influence of Current Constriction on the Impedance of Polarizable Electrodes Application to Fuel Cell Electrodes , 1997 .

[32]  P. Ekdunge,et al.  Modelling the PEM fuel cell cathode , 1997 .

[33]  Edson A. Ticianelli,et al.  Development and electrochemical studies of gas diffusion electrodes for polymer electrolyte fuel cells , 1996 .

[34]  T. Springer,et al.  Characterization of polymer electrolyte fuel cells using ac impedance spectroscopy , 1996 .

[35]  Edson A. Ticianelli,et al.  A modelling approach to the characterization of the limiting polarization behaviour of gas diffusion electrodes , 1995 .

[36]  K. Amouzegar,et al.  Quantitative determination of dispersed platinum in carbon by cyclic voltammetry , 1995 .

[37]  Yong Woo Rho,et al.  Mass Transport Phenomena in Proton Exchange Membrane Fuel Cells Using O 2 / He , O 2 / Ar , and O 2 / N 2 Mixtures I . Experimental Analysis , 1994 .

[38]  T. Springer,et al.  Modeling and Experimental Diagnostics in Polymer Electrolyte Fuel Cells , 1993 .

[39]  N. Giordano,et al.  Nafion Distribution in Gas Diffusion Electrodes for Solid‐Polymer‐Electrolyte‐Fuel‐Cell Applications , 1992 .

[40]  Shimshon Gottesfeld,et al.  High Performance Catalyzed Membranes of Ultra‐low Pt Loadings for Polymer Electrolyte Fuel Cells , 1992 .

[41]  A. Parthasarathy,et al.  High energy efficiency and high power density proton exchange membrane fuel cells: Electrode kinetics and mass transport , 1991 .

[42]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[43]  T. E. Springer,et al.  Electrical Impedance of a Pore Wall for the Flooded‐Agglomerate Model of Porous Gas‐Diffusion Electrodes , 1989 .

[44]  Edson A. Ticianelli,et al.  Localization of platinum in low catalyst loading electrodes to to attain high power densities in SPE fuel cells , 1988 .

[45]  C. R. Derouin,et al.  N 87-29937 ADVANCES IN SOLID POLYMER ELECTROLYTE FUEL CELL TECHNOLOGY WITH LOW-PLATINUM-LOADING ELECTRODES , 2004 .

[46]  G. Squadrito,et al.  Nafion content in the catalyst layer of polymer electrolyte fuel cells: effects on structure and performance , 2001 .

[47]  J. Newman,et al.  Mass Transport in Gas‐Diffusion Electrodes: A Diagnostic Tool for Fuel‐Cell Cathodes , 1998 .

[48]  Allen J. Bard,et al.  Electrochemical Methods: Fundamentals and Applications , 1980 .