Chemical-looping combustion in a 300 W continuously operating reactor system using a manganese-based oxygen carrier

Abstract Chemical-looping combustion (CLC) is a method for the combustion of fuel gas with inherent separation of carbon dioxide. This technique involves the use of two interconnected reactors. A solid oxygen carrier reacts with the oxygen in air in the air reactor and is then transferred to the fuel reactor, where the fuel gas is oxidized to carbon dioxide and water by the oxygen carrier. Fuel gas and air are never mixed and pure CO 2 can easily be obtained from the flue gas exit. The oxygen carrier is recycled between both reactors in a regenerative process. This paper presents the results from a continuously operating laboratory CLC unit, consisting of two interconnected fluidized beds. The feasibility of the use of a manganese-based oxygen carrier supported on magnesium stabilized zirconia was tested in this work. Natural gas or syngas was used as fuel in the fuel reactor. Fuel flow and air flow was varied, the thermal power was between 100 and 300 W, and the air ratio was between 1.1 and 5.0. Tests were performed at four temperatures: 1073, 1123, 1173 and 1223 K. The prototype was successfully operated at all conditions with no signs of agglomeration or deactivation of the oxygen carrier. The same particles were used during 70 h of combustion and the mass loss was 0.038% per hour, although the main quantity was lost in the first hour of operation. In the combustion tests with natural gas, methane was detected in the exit flue gases, while CO and H 2 were maintained at low concentrations. Higher temperature or lower fuel flows increases the combustion efficiency, which ranged from 0.88 to 0.99. On the other hand, the combustion of syngas was complete for all experimental conditions, with no CO or H 2 present in the gas from the fuel reactor.

[1]  A. Lyngfelt,et al.  A fluidized-bed combustion process with inherent CO2 separation; Application of chemical-looping combustion , 2001 .

[2]  A. Abad,et al.  Selection of Oxygen Carriers for Chemical-Looping Combustion , 2004 .

[3]  A. Lyngfelt,et al.  Construction and 100 h of operational experience of a 10-kW chemical looping combustor , 2005 .

[4]  A. Lyngfelt,et al.  Gas leakage measurements in a cold model of an interconnected fluidized bed for chemical-looping combustion , 2003 .

[5]  Toshihiro Okamoto,et al.  Development of a Novel Chemical-Looping Combustion: Synthesis of a Solid Looping Material of NiO/NiAl2O4 , 1999 .

[6]  Selmer M. Johnson,et al.  Chemical Equilibrium in Complex Mixtures , 1958 .

[7]  Anders Lyngfelt,et al.  Multicycle reduction and oxidation of different types of iron oxide particles: Application to chemical-looping combustion , 2004 .

[8]  J. Houghton,et al.  Climate change 2001 : the scientific basis , 2001 .

[9]  Qinhui Wang,et al.  Experimental research on solid circulation in a twin fluidized bed system , 2003 .

[10]  Hermann Hofbauer,et al.  SIMULATION OF MASS AND ENERGY BALANCES OF A CHEMICAL-LOOPING COMBUSTION SYSTEM , 2005 .

[11]  R. Villa.  Ni based mixed oxide materials for CH4 oxidation under redox cycle conditions , 2003 .

[12]  Steven C. Gebhard,et al.  A NOVEL CO2 SEPARATION SYSTEM , 1999 .

[13]  A. Lyngfelt,et al.  A 300 W laboratory reactor system for chemical-looping combustion with particle circulation , 2006 .

[14]  Anders Lyngfelt,et al.  Investigation of Mn3O4 With Stabilized ZrO2 for Chemical-Looping Combustion , 2006 .

[15]  Paul In-Young Cho.  Development and Characterisation of Oxygen-Carrier Materials for Chemical-Looping Combustion , 2005 .

[16]  M. Ishida,et al.  Experimental results of chemical-looping combustion with NiO/NiAl2O4 particle circulation at 1200 °C , 2002 .

[17]  A. Lyngfelt,et al.  Thermal Analysis of Chemical-Looping Combustion , 2006 .

[18]  H. Yoon,et al.  Characteristics of the NiO/hexaaluminate for chemical looping combustion , 2003 .

[19]  A. Lyngfelt,et al.  A Two-Compartment Fluidized Bed Reactor for CO2 Capture by Chemical-Looping Combustion , 2004 .

[20]  Y. O. Chong,et al.  Solids exchange between adjacent fluid beds without gas mixing , 1986 .

[21]  A. Lyngfelt,et al.  Comparison of iron-, nickel-, copper- and manganese-based oxygen carriers for chemical-looping combustion , 2004 .

[22]  A. Abad,et al.  Reduction and Oxidation Kinetics of a Copper-Based Oxygen Carrier Prepared by Impregnation for Chemical-Looping Combustion , 2004 .

[23]  A. Lyngfelt,et al.  Reactivity of some metal oxides supported on alumina with alternating methane and oxygen - Application for chemical-looping combustion , 2003 .