Numerical Modelling of I-Beam Jib Crane with Local Stresses in Wheel Supporting Flanges - Influence of Hoisting Speed

This article presents an approach of numerical modelling of I-beam crane jib, with using the finite element method particularly the most loaded elements at different speeds. One of the possible methods for use in the design process of hoisting dynamics modelling and its effects on the load-carrying structure for the marine jib crane is shown. For proper modelling, the impact of the load and hoisting speed on the load-carrying structure jib, dynamics simulations of hoisting the load using Matlab-Simulink software were carried out and in the field of finite element method. To carry out such a simulation, hybrid calculations had to be applied, where the response from the phenomenological model based on solving a system of differential equations of motion in Matlab-Simulink was used to stimulate the crane I-beam jib during the FEM simulation, which permits to determine dynamic properties of the load-carrying structure for two example different hoisting speeds. The basic strength parameters for a typical light marine jib crane, obtained in the case of static calculations and using the proposed approach between the two computing environments were compared.

[1]  Keum-Shik Hong,et al.  Nonlinear robust control of a hydraulic elevator: experiment-based modeling and two-stage Lyapunov redesign , 2005 .

[2]  Tomasz Haniszewski,et al.  Strength analysis of overhead traveling crane with use of Finite Element Method , 2014 .

[3]  Arunas Andziulis,et al.  Multibody dynamic simulation and transient analysis of quay crane spreader and lifting mechanism , 2016 .

[4]  James S. Davidson,et al.  Buckling of centerline-stiffened plates subjected to uniaxial eccentric compression , 2005 .

[5]  Łukasz Konieczny,et al.  Numerical identification of the overhead travelling crane’s dynamic factor caused by lifting the load off the ground , 2015 .

[6]  Tomasz Haniszewski HYBRID ANALYSIS OF VIBRATION OF THE OVERHEAD TRAVELLING CRANE , 2014 .

[7]  Jerzy Sładek,et al.  A structure's deflection measurement and monitoring system supported by a vision system , 2014 .

[8]  Olga Romaskevich Dynamics of physical systems, normal forms and Markov chains , 2016 .

[9]  Dongjoo Kim,et al.  Evaluation of Displacements and Stresses in Horizontally Curved Beams , 2006 .

[10]  Tomasz Figlus,et al.  Diagnosis of the wear of gears in the gearbox using the wavelet packet transform , 2014 .

[11]  Marijonas Bogdevičius,et al.  Investigation of the dynamics of an overhead crane lifting process in a vertical plane , 2005 .

[12]  J Verschoof Cranes: Design, Practice and Maintenance , 1999 .

[13]  D. Gąska,et al.  Modelling studies on the use of aluminium alloys in lightweight load-carrying crane structures , 2016 .

[14]  Nicholas S. Trahair Lateral–distortional buckling of monorails , 2009 .