Three Dimensional (3D) Microstructural Characterization and Quantitative Analysis of Solidified Microstructures in Magnesium-Based Alloys

Magnesium alloys have the attractive combination of lightweight and strength. An understanding of solidification microstructures in these materials is important. An accurate means of quantifying microstructure in 3D is extremely important. In this study, we have used serial polishing and synchrotron-based x-ray tomography technique as a means of 3D characterization of the solidified microstructures of magnesium-based alloys. These models were also used to conduct quantitative analysis in 3D. The phase fraction and morphologies of intermetallics and α-Mg matrix phase were obtained. The phase fractions of β-Mg17Al12 and Al–Mn intermetallics are consistent with measurements in the literature and calculations based on the Scheil–Gulliver solidification model. Our 3D reconstructions also show that the dendrite morphology has sixfold symmetry. The results of 3D microstructural characterization and analysis will enable a comprehensive understanding of solidification variables, microstructure, and properties.

[1]  Xianghui Xiao,et al.  Damage evolution in SiC particle reinforced Al alloy matrix composites by X-ray synchrotron tomography , 2010 .

[2]  Nikhilesh Chawla,et al.  Three-dimensional (3D) microstructure visualization of LaSn3 intermetallics in a novel Sn-rich rare-earth-containing solder , 2008 .

[3]  R. Trivedi,et al.  Solidification microstructures and solid-state parallels: Recent developments, future directions , 2009 .

[4]  Frank Witte,et al.  Evaluation of short-term effects of rare earth and other elements used in magnesium alloys on primary cells and cell lines. , 2010, Acta biomaterialia.

[5]  E. Willbold,et al.  Biodegradable magnesium scaffolds: Part 1: appropriate inflammatory response. , 2007, Journal of biomedical materials research. Part A.

[6]  T. Pollock.  Weight Loss with Magnesium Alloys , 2010, Science.

[7]  A. Karma,et al.  Crystal-melt interfacial free energies in hcp metals: A molecular dynamics study of Mg , 2006 .

[8]  Dendritic morphology of α-Mg during the solidification of Mg-based alloys: 3D experimental characterization by X-ray synchrotron tomography and phase-field simulations , 2011 .

[9]  J. Mathews.  Upon the constitution of binary alloys , 1902 .

[10]  J. Langer,et al.  Pattern formation in nonequilibrium physics , 1999 .

[11]  F. Wittea,et al.  In vivo corrosion of four magnesium alloys and the associated bone response , 2004 .

[12]  J. Langer.  Instabilities and pattern formation in crystal growth , 1980 .

[13]  E. Scheil.  Bemerkungen zur Schichtkristallbildung , 1942 .

[14]  H. K. D. H. Bhadeshia,et al.  Phase-field model study of the crystal morphological evolution of hcp metals , 2009 .

[15]  J. Hoyt,et al.  Molecular dynamics simulations of the crystal–melt interface mobility in HCP Mg and BCC Fe , 2010 .

[16]  A. Karma,et al.  Atomistic and continuum modeling of dendritic solidification , 2003 .

[17]  E. Willbold,et al.  Biodegradable magnesium scaffolds: Part II: peri-implant bone remodeling. , 2007, Journal of biomedical materials research. Part A.

[18]  J. Hoyt,et al.  Molecular dynamics calculations of the crystal-melt interfacial mobility for hexagonal close-packed Mg , 2007 .

[19]  R. S. Sidhu,et al.  Three-dimensional microstructure characterization of Ag3Sn intermetallics in Sn-rich solder by serial sectioning , 2004 .

[20]  Eshel Ben-Jacob,et al.  The artistry of nature , 2001, Nature.