A unified point-by-point planning algorithm of machining fixture layout for complex workpiece

Workpiece-fixturing is necessary to achieve the correct position of the workpiece with respect to the cutting tool. Therefore, a unified point-by-point planning algorithm of fixture layout is systematically created for a complex workpiece based on the discretization thought. Firstly, based on the inclusion of the theoretical Degrees of Freedom (DOFs) within the practical DOFs and the relationship between the locator number and the rank of Jacobian matrix, two necessary and sufficient conditions are suggested for the judgment criterion of locating determination. According to the variation of locating reference and locator number, a planning algorithm of locating layout is further established by iteratively analysing the locating determination. Secondly, the combination of the virtual work principle with the linear programming technology is employed to formulate a judgment criterion for fixturing stability. Consequently, with the discretization of clamping surfaces, a deterministic algorithm of clamping force is suggested by evaluating the fixturing stability at every node. Three typical examples are finally used to demonstrate the design procedure of fixture layout.

[1]  Y. Kang,et al.  Computer‐aided fixture design verification , 2002 .

[2]  K. P. Arulshri,et al.  Machining fixture layout design using ant colony algorithm based continuous optimization method , 2009 .

[3]  John M. Watts,et al.  Analysis and synthesis , 1985 .

[4]  Yiming Rong,et al.  Computer-Aided Fixture Design : Manufacturing Engineering and Materials Processing Series/55 , 1999 .

[5]  Weihong Zhang,et al.  A Machining-Dimension-Based Approach to Locating Scheme Design , 2008 .

[6]  H. Harry Asada,et al.  Kinematic analysis of workpart fixturing for flexible assembly with automatically reconfigurable fixtures , 1985, IEEE J. Robotics Autom..

[7]  Kathrin Abendroth.  Advanced Computer Aided Fixture Design , 2016 .

[8]  Jianbin Xue,et al.  Deformation control through fixture layout design and clamping force optimization , 2008 .

[9]  Yiming Rong,et al.  Locating completeness evaluation and revision in fixture plan , 2005 .

[10]  Shahram Payandeh,et al.  Modeling and analysis of flexible fixturing systems for agile manufacturing , 1996, 1996 IEEE International Conference on Systems, Man and Cybernetics. Information Intelligence and Systems (Cat. No.96CH35929).

[11]  K. Rong,et al.  Computer-Aided Fixture Design , 1999 .

[12]  Michael Yu Wang,et al.  Tolerance Analysis for Fixture Layout Design , 2002 .

[13]  Weihong Zhang,et al.  A mathematical approach to analysis and optimal design of a fixture locating scheme , 2006 .

[14]  Andrew Y. C. Nee,et al.  Computer-Aided Fixture Design , 1995 .

[15]  S. Jack Hu,et al.  A Variational Method of Robust Fixture Configuration Design for 3-D Workpieces , 1997 .

[16]  M. M. Barash,et al.  A Mathematical Approach to Automatic Configuration of Machining Fixtures: Analysis and Synthesis , 1989 .

[17]  Weihong Zhang,et al.  Modeling and analysis of workpiece stability based on the linear programming method , 2007 .