Long-term rail profile damage in a railway crossing: Field measurements and numerical simulations

Abstract Railway crossings are subjected to a severe load environment leading to a degradation of rail profiles due to wear and accumulated plastic deformation. This damage is the result of the high magnitudes of contact pressure and traction generated in the wheel–rail contact during each wheel transition between wing rail and crossing nose. An extensive measurement campaign has been carried out at a test site in Austria in a particularly severely loaded crossing manufactured from an explosion depth hardened (EDH) manganese steel grade. For an accumulated traffic load of 65 Mega-Gross-Tonnes (MGT), the evolution of profile degradation for 16 cross-sections along the crossing rail has been recorded on multiple occasions. The results from the measurement campaign are used to validate a previously presented multidisciplinary and iterative simulation methodology for the prediction of long-term rail damage. It is shown that the predicted rail profile degradation exceeds the measured degradation for some of the cross-sections but generally a good qualitative agreement is observed. Possible reasons for the higher predicted damage are the uncertain distribution of traffic at the test site and differences in material properties between the crossing in the field and the test specimens used for calibration of the cyclic plasticity model. The influence of the frequency of updating the rail profiles in the iterative simulation methodology, and the compromise between computational cost and the number of load cases accounted for in the applied load sequence, are addressed.

[1]  Jens C. O. Nielsen,et al.  Track gauge optimisation of railway switches using a genetic algorithm , 2012 .

[2]  Simon Iwnicki,et al.  The Manchester Benchmarks for Rail Vehicle Simulation , 1998 .

[3]  Björn Pålsson,et al.  Optimisation of railway crossing geometry considering a representative set of wheel profiles , 2015 .

[4]  Jens C. O. Nielsen,et al.  Wheel–rail interaction and damage in switches and crossings , 2012 .

[5]  Werner Daves,et al.  Simplified explicit finite element model for the impact of a wheel on a crossing – Validation and parameter study , 2017 .

[6]  Magnus Ekh,et al.  Metamodelling of wheel–rail normal contact in railway crossings with elasto-plastic material behaviour , 2018, Engineering with Computers.

[7]  J. Nielsen,et al.  Prediction of plastic deformation and wear in railway crossings – Comparing the performance of two rail steel grades , 2019, Wear.

[8]  Chen Shen,et al.  Wheel–Rail Impact at Crossings: Relating Dynamic Frictional Contact to Degradation , 2017 .

[9]  Xin Li,et al.  Simulation of vertical dynamic vehicle-track interaction in a railway crossing using Green's functions , 2017 .

[10]  Jens C. O. Nielsen,et al.  Dynamic vehicle–track interaction in switches and crossings and the influence of rail pad stiffness – field measurements and validation of a simulation model , 2015 .

[11]  N. Ohno,et al.  Kinematic hardening rules with critical state of dynamic recovery, part I: formulation and basic features for ratchetting behavior , 1993 .

[12]  Tim J. Harrison,et al.  Dynamic analysis and performance of a repoint track switch , 2020 .

[13]  Tomas Jendel,et al.  Prediction of wheel profile wear—comparisons with field measurements , 2002 .

[14]  Jens C. O. Nielsen,et al.  Simulation of wheel-rail contact and damage in switches & crossings , 2009 .

[15]  Jens C. O. Nielsen,et al.  Dynamic interaction between train and railway turnout: full-scale field test and validation of simulation models , 2008 .

[16]  Werner Daves,et al.  A wheel passing a crossing nose: Dynamic analysis under high axle loads using finite element modelling* , 2012 .

[17]  A. Olsson,et al.  On Latin hypercube sampling for structural reliability analysis , 2003 .

[18]  J. Archard.  Contact and Rubbing of Flat Surfaces , 1953 .

[19]  Jens C. O. Nielsen,et al.  Assessment of methods for calculating contact pressure in wheel–rail/switch contact , 2006 .

[20]  Kevin Sawley,et al.  The formation of hollow-worn wheels and their effect on wheel/rail interaction , 2005 .

[21]  Jens C. O. Nielsen,et al.  Train-Track Interaction and Mechanisms of Irregular Wear on Wheel and Rail Surfaces , 2003 .

[22]  J. J. Kalker,et al.  A Fast Algorithm for the Simplified Theory of Rolling Contact , 1982 .

[23]  Jens Reinecke,et al.  Simulation of wheel–rail contact and subsequent material degradation in switches & crossings , 2009 .

[24]  Hein Putter,et al.  The bootstrap: a tutorial , 2000 .