A General Fluid Dynamic Analysis of Drop Ejection in Drop-on-Demand Ink Jet Devices

Drop-on-demand devices are the heart of most modern ink jet printers. The fluid dynamic process during drop ejection is complex with time-dependent fluid interface disruptions. Based on computations with a generic problem configuration, the present work attempts to provide an insight into the drop ejection behavior for establishing general design rules in device development. The computational results show that the volume of ejected drop is very close to the volume of fluid pushed through the nozzle by an actuation pulse. The speed of the ejected drop is typically between one third and two thirds of the average velocity of the fluid pushed through the nozzle during actuation. The conditions for obtaining various (desirable or undesirable) drop shapes immediately after ejection are examined. The cases when drops may not be successfully ejected are also discussed.

[1]  Jingkuang Chen,et al.  Numerical simulation of fluid-structure interaction in a MEMS diaphragm drop ejector , 2002 .

[2]  Arthur C. Wilbur,et al.  Ink Jet Printing , 1987, Photonics West - Lasers and Applications in Science and Engineering.

[3]  C. W. Hirt,et al.  Volume of fluid (VOF) method for the dynamics of free boundaries , 1981 .

[4]  F. J. Kamphoefner.  Ink jet printing , 1972 .

[5]  G. Batchelor,et al.  An Introduction to Fluid Dynamics , 1968 .

[6]  Masahiro Fujii,et al.  A low power, small, electrostatically-driven commercial inkjet head , 1998, Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.

[7]  Xerox,et al.  Drop-On-Demand Ink Jet Transducer Effectiveness , 1998 .