论文信息 - Audio power amplifier using in cellular phone with improved PSRR

Audio power amplifier using in cellular phone with improved PSRR

A fully differential folded-cascode op-amp is applied into the audio power amplifier successfully. PSRR (power supply rejection ratio) of whole chip is higher than 60 dB between 20 Hz and 20 kHz, especially 82 dB at 217 Hz. Analysis and simulation has shown that PSRR of both op-amp and whole chip are improved. As a result, improved PSRR reduces the effect of noise on power supply lines being picked up and intensified by the audio power amplifier using cellular phone. The chip is manufactured by CSMC 0.6/spl mu/m, 3.3 V/5 V, 2P2M, CMOS process.

Feng Quanyuan | Li Jianlong

[1] M. A. Copeland,et al. Design techniques for cascoded CMOS op amps with improved PSRR and common-mode input range , 1984 .

[2] Willy Sansen,et al. Power supply rejection ratio in operational transconductance amplifiers , 1990 .

[3] Hakan Kuntman,et al. Accurate and high output impedance current mirror suitable for CMOS current output stages , 1997 .

[4] A. B. Bhattacharyya,et al. Sub-circuit analysis for power supply rejection ratio in regulated cascode operational transconductance amplifiers and filters , 1999, Proceedings Twelfth International Conference on VLSI Design. (Cat. No.PR00013).

[5] Rahul Sarpeshkar,et al. A low-power high-PSRR current-mode microphone preamplifier , 2003, IEEE J. Solid State Circuits.