Laser-induced shock compression of monocrystalline copper : characterization and analysis

Controlled laser experiments were used to generate ultra-short shock pulses of approximately 5 ns duration in monocrystalline copper specimens with [001] orientation. Transmission electron microscopy revealed features consistent with previous observations of shock-compressed copper, albeit at pulse durations in the μs regime. At pressures of 12 and 20 GPa, the structure consists primarily of dislocation cells; at 40 GPa, twinning and stacking-fault bundles are the principal defect structures; and at a pressure of 55–60 GPa, the structure shows micro-twinning and the effects of thermal recovery (elongated sub-grains). The results suggest that the defect structure is generated at the shock front; the substructures observed are similar to the ones at much larger durations. The dislocation generation is discussed, providing a constitutive description of plastic deformation. It is proposed that thermally activated loop nucleation at the front is the mechanism for dislocation generation. A calculational method for dislocation densities is proposed, based on nucleation of loops at the shock front and their extension due to the residual shear stresses behind the front. Calculated dislocation densities compare favorably with experimentally observed results. It is proposed that simultaneous diffraction by Laue and Bragg of different lattice planes at the shock front can give the strain state and the associated stress level at the front. This enables the calculation of the plastic flow resistance at the imposed strain rate. An estimated strength of 435 MPa is obtained, for a strain rate of 1.3 × 0 s . The threshold stress for deformation twinning in shock compression is calculated from the constitutive equations for slip, twinning, and the Swegle–Grady relationship. The calculated threshold pressure for the [001] orientation is 16.3 GPa.  2003 Acta Materialia Inc. Published by Elsevier Science Ltd. All rights reserved.