Synthesis and Characterization of Atomically Flat Methyl-Terminated Ge(111) Surfaces.

Atomically flat, terraced H-Ge(111) was prepared by annealing in H2(g) at 850 °C. The formation of monohydride Ge-H bonds oriented normal to the surface was indicated by angle-dependent Fourier-transform infrared (FTIR) spectroscopy. Subsequent reaction in CCl3Br(l) formed Br-terminated Ge(111), as shown by the disappearance of the Ge-H absorption in the FTIR spectra concomitant with the appearance of Br photoelectron peaks in X-ray photoelectron (XP) spectra. The Br-Ge(111) surface was methylated by reaction with (CH3)2Mg. These surfaces exhibited a peak at 568 cm(-1) in the high-resolution electron energy loss spectrum, consistent with the formation of a Ge-C bond. The absorption peaks in the FTIR spectra assigned to methyl "umbrella" and rocking modes were dependent on the angle of the incident light, indicating that the methyl groups were bonded directly atop surface Ge atoms. Atomic-force micrographs of CH3-Ge(111) surfaces indicated that the surface remained atomically flat after methylation. Electrochemical scanning-tunneling microscopy showed well-ordered methyl groups that covered nearly all of the surface. Low-energy electron diffraction images showed sharp, bright diffraction spots with a 3-fold symmetry, indicating a high degree of order with no evidence of surface reconstruction. A C 1s peak at 284.1 eV was observed in the XP spectra, consistent with the formation of a C-Ge bond. Annealing in ultrahigh vacuum revealed a thermal stability limit of ∼400 °C of the surficial CH3-Ge(111) groups. CH3-Ge(111) surfaces showed significantly greater resistance to oxidation in air than H-Ge(111) surfaces.

[1]  N. Lewis,et al.  High-resolution X-ray photoelectron spectroscopic studies of alkylated silicon(111) surfaces. , 2005, The journal of physical chemistry. B.

[2]  D. Law,et al.  40% efficient metamorphic GaInP∕GaInAs∕Ge multijunction solar cells , 2007 .

[3]  N. Lewis,et al.  Transmission Infrared Spectra of CH3–, CD3–, and C10H21–Ge(111) Surfaces , 2011 .

[4]  R. Wolkow,et al.  Covalent bonding of thiophenes to Si(111) by a halogenation/thienylation route , 1998 .

[5]  G. Lu,et al.  The adsorption and thermal decomposition of digermane on Ge(111) , 1993 .

[6]  Y. Chabal,et al.  Hydrogen passivation of germanium (100) surface using wet chemical preparation , 2005 .

[7]  A. Kasuya,et al.  HREELS, STM, and STS study of CH(3)-terminated Si(111)-(1x1) surface. , 2004, The Journal of chemical physics.

[8]  E. Johansson,et al.  Helium atom diffraction measurements of the surface structure and vibrational dynamics of CH(3)-Si(111) and CD(3)-Si(111) surfaces. , 2010, The Journal of chemical physics.

[9]  G. S. Higashi,et al.  Comparison of Si(111) surfaces prepared using aqueous solutions of NH4F versus HF , 1991 .

[10]  W. Jaegermann,et al.  Chemical and electronic characterization of methyl-terminated Si(111) surfaces by high-resolution synchrotron photoelectron spectroscopy , 2005 .

[11]  N. Lewis,et al.  Passivation and Secondary Functionalization of Allyl-Terminated Si(111) Surfaces , 2008 .

[12]  W. H. Weinberg,et al.  Alkylation of Si Surfaces Using a Two-Step Halogenation/Grignard Route , 1996 .

[13]  S. Solares,et al.  Low-temperature STM images of methyl-terminated Si(111) surfaces. , 2005, The journal of physical chemistry. B.

[14]  Gerald Siefer,et al.  Current-matched triple-junction solar cell reaching 41.1% conversion efficiency under concentrated sunlight , 2009 .

[15]  Martin M. Frank,et al.  Hafnium oxide gate dielectrics on sulfur-passivated germanium , 2006 .

[16]  Y. Chabal,et al.  Ideal hydrogen termination of the Si (111) surface , 1990 .

[17]  G. Hughes,et al.  An X-ray photoelectron spectroscopy study of the HF etching of native oxides on Ge(111) and Ge(100) surfaces , 1998 .

[18]  T. Osaka,et al.  Detection of C-Si covalent bond in CH3 adsorbate formed by chemical reaction of CH3MgBr and H:Si(111). , 2003, Journal of the American Chemical Society.

[19]  K. Nagashio,et al.  Atomically flat planarization of Ge(100), (110), and (111) surfaces in H2 annealing , 2014 .

[20]  N. Lewis,et al.  Chemical and electrical passivation of silicon (111) surfaces through functionalization with sterically hindered alkyl groups. , 2006, The journal of physical chemistry. B.

[21]  T. Osaka,et al.  Electrochemical Behavior of Methyl- and Butyl- Terminated Si(111) in Aqueous Solution , 2004 .

[22]  N. Lewis,et al.  Investigation of the Reactions during Alkylation of Chlorine-Terminated Silicon (111) Surfaces , 2007 .

[23]  W. Jaegermann,et al.  High-Resolution Synchrotron Photoemission Studies of the Electronic Structure and Thermal Stability of CH3- and C2H5-Functionalized Si(111) Surfaces , 2007 .

[24]  M. Straumanis,et al.  Lattice Parameters, Coefficients of Thermal Expansion, and Atomic Weights of Purest Silicon and Germanium , 1952 .

[25]  Geert Hellings,et al.  Germanium MOSFET Devices: Advances in Materials Understanding, Process Development, and Electrical Performance , 2008 .

[26]  Shinichi Takagi,et al.  Hole mobility enhancement of p-MOSFETs using global and local Ge-channel technologies , 2006 .

[27]  Nathan S. Lewis,et al.  Comparison of the Electrical Properties and Chemical Stability of Crystalline Silicon(111) Surfaces Alkylated Using Grignard Reagents or Olefins with Lewis Acid Catalysts , 2003 .

[28]  N. Lewis,et al.  Chemical, Electronic, and Electrical Properties of Alkylated Ge(111) Surfaces , 2010 .

[29]  S. Bent,et al.  Reactivity of the germanium surface: Chemical passivation and functionalization. , 2006, Annual review of physical chemistry.

[30]  N. Lewis,et al.  Infrared and X-ray Photoelectron Spectroscopic Studies of the Reactions of Hydrogen-Terminated Crystalline Si(111) and Si(100) Surfaces with Br2, I2, and Ferrocenium in Alcohol Solvents , 2002 .

[31]  N. Lewis,et al.  What a difference a bond makes: the structural, chemical, and physical properties of methyl-terminated Si(111) surfaces. , 2014, Accounts of chemical research.