Geometry optimization of MR valves constrained in a specific volume using the finite element method

This paper presents the geometric optimal design of magnetorheological (MR) valves in order to improve valve performance, such as pressure drop. The optimization problem is to find the optimal geometric dimensions of MR valves constrained in a specific volume. After describing the configuration of MR valves, their pressure drops are investigated on the basis of the Bingham model of an MR fluid. Then, the valve ratio, which is an objective function, is derived by considering the field-dependent (controllable) and viscous (uncontrollable) pressure drops of the MR valves. Subsequently, the optimization procedure using a golden-section algorithm and a local quadratic fitting technique is constructed via a commercial finite element method (FEM) parametric design language. From the constructed optimization tool, optimal solutions of the MR valves, which are constrained in a specific cylindrical volume defined by its radius and height, are calculated and compared with analytical ones. In addition, several different types of MR valves are optimized in the same specific volume and results are presented.

[1]  S. J. Lin,et al.  A Dynamic Model of the Flapper-Nozzle Component of an Electrohydraulic Servovalve , 1989 .

[2]  William Kordonski,et al.  Magnetorheological Throttle Valve in Passive Damping Systems , 1998 .

[3]  N. Wereley,et al.  Nondimensional analysis of semi-active electrorheological and magnetorheological dampers using approximate parallel plate models , 1998 .

[4]  Seung-Bok Choi,et al.  Comparison of Field-Controlled Characteristics between ER and MR Clutches , 1999 .

[5]  Seung-bok Choi,et al.  Control and Response Characteristics of a Magneto-Rheological Fluid Damper for Passenger Vehicles , 2000 .

[6]  Norman M. Wereley,et al.  Design of a High-Efficiency Magnetorheological Valve , 2002 .

[7]  Seung-Bok Choi,et al.  Vibration control of a passenger car using MR engine mounts , 2002, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[8]  Walid H. El-Aouar.  Finite Element Analysis Based Modeling of Magneto Rheological Dampers , 2002 .

[9]  Norman M. Wereley,et al.  Nondimensional Damping Analysis of Flow-Mode Magnetorheological and Electrorheological Dampers , 2003 .

[10]  H. Du,et al.  Finite Element Analysis and Simulation Evaluation of a Magnetorheological Valve , 2003 .

[11]  Nicholas C. Rosenfeld,et al.  Volume-constrained optimization of magnetorheological and electrorheological valves and dampers , 2004 .

[12]  D. H. Wang,et al.  Design and Modeling of a Magnetorheological Valve with Both Annular and Radial Flow Paths , 2006 .