Influence of the relative humidity on film formation by vapor induced phase separation

The formation of polymer films produced by the phase separation process occurring when a cast poly(etherimide)/N-Methyl-2-Pyrrolidone solution was exposed to humid air was studied. It was found that above a relative humidity value of 27%, the films presented a cell-like structure. The size of the cells was shown to decrease when the relative humidity increased. This effect was more pronounced at the film/substrate interface than near the surface. A cell-size gradient from one face of the film to the other was also clearly observed. A phenomenological model has been proposed to explain the morphology obtained by a phase separation induced by the water vapor in the studied system, taking into account thermodynamics and kinetics considerations. In this model, the cell-like structure setting up is shown to result from a nucleation and growth process accompanied by a coalescence coarsening. It was illustrated by a composition path on the ternary phase diagram. It was shown how the relative humidity influenced the film composition leading to the preferential nucleation compared to the growth and coalescence of the cells. Finally, it was found that the cell-size anisotropy resulted in the solvent and non-solvent mass transfers in the film, bringing to the fore the determining role of kinetics.

[1]  S. Nunes,et al.  Membranes of poly(ether imide) and nanodispersed silica , 1999 .

[2]  A. Viallat,et al.  Charge-transfer interaction and chain association in poly(ether imide) solutions: a fluorescence spectroscopic study , 1994 .

[3]  D. Soong,et al.  Polymer membrane formation through the thermal-inversion process. 1. Experimental study of membrane structure formation , 1985 .

[4]  Hideto Matsuyama,et al.  Membrane formation via phase separation induced by penetration of nonsolvent from vapor phase. I. Phase diagram and mass transfer process , 1999 .

[5]  Jan Feijen,et al.  Phase-Separation Processes in Polymer-Solutions in Relation to Membrane Formation , 1996 .

[6]  D. Bhattacharyya,et al.  Changes in morphology and transport characteristics of polysulfone membranes prepared by different demixing conditions , 1995 .

[7]  Robert E. Wilson,et al.  Fundamentals of momentum, heat, and mass transfer , 1969 .

[8]  S. Hwang,et al.  Formation of asymmetric polysulfone membranes by immersion precipitation. Part I. Modelling mass transport during gelation , 1992 .

[9]  J. Pinto,et al.  Modeling and simulation of the phase‐inversion process during membrane preparation , 2001 .

[10]  S. Nunes,et al.  Evidence for spinodal decomposition and nucleation and growth mechanisms during membrane formation , 1996 .

[11]  D. R. Lloyd,et al.  Formation of anisotropic membranes via thermally induced phase separation , 1999 .

[12]  Kang Li,et al.  Phase separation in polyetherimide/solvent/nonsolvent systems and membrane formation , 1999 .

[13]  Y. Kang,et al.  Membrane formation by water vapor induced phase inversion , 1999 .

[14]  J. Bohdziewicz,et al.  Porous polycarbonate phase-inversion membranes , 1991 .

[15]  W. Albrecht.  Formation of hollow fiber membranes from poly(ether imide) at wet phase inversion using binary mixtures of solvents for the preparation of the dope , 2001 .