Charpy absorbed energy in simulated heat-affected zone of laser-arc hybrid welded joints by high-strength steel for bridge structures

[1]  Zhiyi Zhang,et al.  Effect of the Cooling Rate of Thermal Simulation on the Microstructure and Mechanical Properties of Low-Carbon Bainite Steel by Laser-Arc Hybrid Welding , 2022, Coatings.

[2]  K. Gotoh,et al.  Expansion of laser–arc hybrid welding to horizontal and vertical-up welding , 2022, Welding in the World.

[3]  N. Matsumoto,et al.  An investigation on laser-arc hybrid welding of one-pass full-penetration butt-joints for steel bridge members , 2021, Welding in the World.

[4]  N. Matsumoto,et al.  Application of Laser-Arc Hybrid Welding to Thick Steel Plates for Bridge Structures , 2020 .

[5]  A. Firsova,et al.  Feasibility Study of Hybrid Laser Arc Welding Application in Shipbuilding , 2019, Key Engineering Materials.

[6]  Yunbo Chen,et al.  Effect of Carbon Content on Abrasive Impact Wear Behavior of Cr-Si-Mn Low Alloy Wear Resistant Cast Steels , 2019, Front. Mater..

[7]  N. Matsumoto,et al.  Influence of laser-arc hybrid welding conditions on cold cracking generation , 2019, Welding in the World.

[8]  Bappa Acherjee,et al.  Hybrid laser arc welding: State-of-art review , 2018 .

[9]  F. Minami,et al.  Toughness assessments of laser arc-hybrid welds of ultra high strength steel , 2017, Welding in the World.

[10]  F. Minami,et al.  Evaluation of Charpy impact toughness using side-grooved specimen for hybrid laser-arc welds of ultra-high-strength steel , 2016, Welding in the World.

[11]  F. Minami,et al.  Prediction of ductile fracture path in Charpy V-notch specimen for laser beam welds , 2015, Welding in the World.

[12]  Jae-Yik Lee,et al.  Determination of Dominant Factors in High Accuracy Prediction of Welding Distortion , 2010 .

[13]  Lin Li,et al.  A comparison of residual stresses in multi pass narrow gap laser welds and gas-tungsten arc welds in AISI 316L stainless steel , 2014 .

[14]  Seiji Katayama,et al.  Elucidation of laser welding phenomena and factors affecting weld penetration and welding defects , 2010 .

[15]  Hiroshi Koga,et al.  First Application of Hybrid Laser-arc Welding to Commercial Ships , 2010 .