Selection of the conveyor belt material for edible film production by a continuous casting process

The scaling up of the wet process and the design of a coating line to produce edible films, require the consideration of several factors such as, the film formulation, drying kinetics of the films, and the selection of a suitable support material in which to pour the solution. This work aimed to select the most suitable material for the construction of a conveyor belt for the fabrication of edible films through the wet process. The surface properties of the starch filmforming solution were determined. Several commercial materials for conveyor belts were tested. The film-forming solution spreadability and work of adhesion were determined. The mechanical behavior of the dry film was evaluated through mechanical properties and peeling resistance. All materials tested showed good performance under the operational conditions assayed to obtain edible films. Finally, the polyurethane band was chosen due to its appropriate performance and lower cost.

[1]  Sabu Thomas,et al.  Polymers for Packaging Applications , 2014 .

[2]  M. Chaudhury,et al.  Interfacial Lifshitz-van der Waals and polar interactions in macroscopic systems , 1988 .

[3]  E. Mäder,et al.  Acid–base interactions and covalent bonding at a fiber–matrix interface: contribution to the work of adhesion and measured adhesion strength , 2000 .

[4]  N. Gontard,et al.  Agro-polymers for edible and biodegradable films: Review of agricultural polymeric materials, physical and mechanical characteristics , 2005 .

[5]  A. Baldan.  Adhesion phenomena in bonded joints , 2012 .

[6]  W. A. Zisman,et al.  Relation of the Equilibrium Contact Angle to Liquid and Solid Constitution , 1964 .

[7]  S. Chapman,et al.  Edible films and coatings: a review. , 2004 .

[8]  Kerry C. Huber,et al.  Edible films and coatings for food applications , 2009 .

[9]  S. Matiacevich,et al.  Wetting behavior of chitosan solutions on blueberry epicarp with or without epicuticular waxes , 2011 .

[10]  A. Jiménez,et al.  Active edible films: Current state and future trends , 2016 .

[11]  A. M. Slavutsky,et al.  Standard and New Processing Techniques Used in the Preparation of Films and Coatings at the Lab Level and Scale-Up , 2016 .

[12]  A. Rudawska,et al.  Evaluating uncertainty of surface free energy measurement by the van Oss-Chaudhury-Good method , 2018 .

[13]  G. Bierwagen.  Film coating technologies and adhesion , 1992 .

[14]  C. Volpe,et al.  Some Reflections on Acid-Base Solid Surface Free Energy Theories , 1997, Journal of colloid and interface science.

[15]  A. M. Slavutsky,et al.  Formulation and characterization of nanolaminated starch based film , 2015 .

[16]  H. Erbil,et al.  Determination of surface free energy components of polymers from contact angle data using nonlinear programming methods , 1988 .

[17]  J. Teixeira,et al.  Chitosan coating surface properties as affected by plasticizer, surfactant and polymer concentrations in relation to the surface properties of tomato and carrot , 2008 .

[18]  Sina Ebnesajjad,et al.  Handbook of biopolymers and biodegradable plastics : properties, processing and applications , 2013 .

[19]  Edgar B. Gutoff,et al.  Water- and solvent-based coating technology , 2016 .