The effect of stitching errors on the spectral characteristics of DFB lasers fabricated using electron beam lithography

Field stitching errors and their effect on the single-mode characteristics of distributed feedback (DFB) lasers fabricated using electron beam lithography were investigated. The stitching errors are associated with small-area, high-resolution electron beam exposure, which has the potential advantage of high-speed writing of laser gratings. Measurements show that the errors are composed of a systematic and a stochastic part. Their effect on the gain margin was simulated both for lambda /4 phase-shifted and optimized multiple-phase-shifted DFB lasers. Simulations show that the lasers are insensitive to the systematic part of the stitching errors if the number of errors is large enough. The stochastic part was found to give rise to a variation in gain margin of the DFB lasers. It is concluded that the field stitching accuracy in the high-resolution mode of a commercial system for electron beam lithography is sufficient to provide a high yield of single-mode lasers. However, it is essential that certain precautions be taken considering exposure conditions and that a fault tolerant laser design be used. >

[1]  A. W. Nelson,et al.  High-quality InP surface corrugations for 1.55 μm InGaAsP DFB lasers fabricated using electron-beam lithography , 1982 .

[2]  Hiroshi Ishikawa,et al.  Long-cavity multiple-phase-shift distributed feedback laser diode for linewidth narrowing , 1990 .

[3]  B. Tromborg,et al.  Theory of linewidth for multielectrode laser diodes with spatially distributed noise sources , 1991 .

[4]  K. Utaka,et al.  Analysis of quarter-wave-shifted DFB laser , 1984 .

[5]  Gunnar Björk,et al.  A new exact and efficient numerical matrix theory of complicated laser structures: properties of asymmetric phase-shifted DFB lasers , 1987 .

[6]  Richard Schatz,et al.  Longitudinal spatial instability in symmetric semiconductor lasers due to spatial hole burning , 1992 .

[7]  Govind P. Agrawal,et al.  Distributed feedback lasers with multiple phase‐shift regions , 1988 .

[8]  Minoru Maeda,et al.  Fabrication of First-Order Gratings for GaAs/AlGaAs LD's by EB Lithography , 1990 .

[9]  Thomas Sphicopoulos,et al.  A tractable above-threshold model, for the design of DFB and phase-shifted DFB lasers , 1991 .

[10]  N. Chinone,et al.  Stability of the longitudinal mode in lambda /4-shifted InGaAsP/InP DFB lasers , 1989 .

[11]  N. Chinone,et al.  Corrugation-pitch-modulated phase-shifted DFB laser , 1989, IEEE Photonics Technology Letters.

[12]  T. Kimura,et al.  Linewidth reduction by coupled phase-shift distributed-feedback lasers , 1987 .

[13]  Y. Ohkura,et al.  1.3- mu m distributed feedback laser diode with a grating accurately controlled by a new fabrication technique , 1989 .

[14]  Shigehisa Arai,et al.  Dynamic single-mode semiconductor lasers with a distributed reflector , 1983 .

[15]  Fumio Koyama,et al.  1.5 μm phase-shifted DFB lasers for single-mode operation , 1984 .

[16]  B. Tromborg,et al.  Linewidth rebroadening in DFB lasers due to weak side modes , 1991, IEEE Photonics Technology Letters.

[17]  S. Yamakoshi,et al.  Stability in single longitudinal mode operation in GaInAsP/InP phase-adjusted DFB lasers , 1987 .