A general solution to the identification of moving vehicle forces on a bridge

Bridge weigh-in-motion systems measure bridge strain caused by the passing of a truck to estimate static axle weights. For this calculation, they commonly use a static algorithm that takes the bridge influence line as reference. Such a technique relies on adequate filtering to remove bridge dynamics and noise. However, filtering can lead to the loss of a significant component of the underlying signal in bridges where the vibration does not have time to complete sufficient number of cycles and in cases of closely spaced axles traveling at high vehicle speeds. In order to overcome these limitations and also to provide additional information on the dynamics of the applied forces, this paper presents an algorithm based on first-order Tikhonov regularization and dynamic programming. First, strain measurements are simulated using an elaborate three-dimensional vehicle and orthotropic bridge interaction system. Then, strain is contaminated with noise and input into the moving force identification algorithm. The procedure to implement the algorithm and to derive the applied forces from the simulated strain record is described. Vehicle axle forces are shown to be accurately predicted for smooth and rough road profiles and a range of speeds. Copyright © 2008 John Wiley & Sons, Ltd.

[1]  A Znidaric,et al.  Slovenian experience of using WIM data for road planning and maintenance , 2005 .

[2]  S. S. Law,et al.  ORTHOGONAL FUNCTION IN MOVING LOADS IDENTIFICATION ON A MULTI-SPAN BRIDGE , 2001 .

[3]  Poul Henning Kirkegaard,et al.  Heavy Vehicles on Minor Highway Bridges: dynamic modelling of vehicles and bridges , 1997 .

[4]  Xinqun Zhu,et al.  MOVING FORCES IDENTIFICATION ON A MULTI-SPAN CONTINUOUS BRIDGE , 1999 .

[5]  L. G. Jaeger,et al.  Dynamics of structures , 1990 .

[6]  Tommy H.T. Chan,et al.  Moving force identification - A frequency and time domains analysis , 1999 .

[7]  S. S. Law,et al.  Time domain identification of moving loads on bridge deck. , 2003 .

[8]  R. Bellman,et al.  Introduction to Mathematical Theory of Control Processes.@@@Control and Dynamic Systems.@@@Mathematical Methods of Optimal Control. , 1974 .

[9]  S. S. Law,et al.  Moving loads identification through regularization , 2002 .

[10]  Roy R. Craig,et al.  Structural Dynamics: An Introduction to Computer Methods , 1981 .

[11]  Tommy H.T. Chan,et al.  A theoretical study of force identification using prestressed concrete bridges , 2000 .

[12]  S. S. Law,et al.  Regularization in moving force identification , 2001 .

[13]  H. R. Busby,et al.  Optimal regularization of an inverse dynamics problem , 1997 .

[14]  Tommy H.T. Chan,et al.  Moving Force Identification based on the Frequency-Time Domain Method , 2003 .

[15]  Eugene J. O'Brien,et al.  Comparison of two independently developed bridge weigh–in–motion systems , 1999 .

[16]  S. S. Law,et al.  An interpretive method for moving force identification , 1999 .

[17]  A. Cifuentes.  Dynamic response of a beam excited by a moving mass , 1989 .

[18]  Tommy H.T. Chan,et al.  Identification of multi-axle vehicle loads on bridges , 2004 .

[19]  Fred Moses,et al.  Weigh-In-Motion System Using Instrumented Bridges , 1979 .

[20]  Per Christian Hansen,et al.  Analysis of Discrete Ill-Posed Problems by Means of the L-Curve , 1992, SIAM Rev..

[21]  S. S. Law,et al.  Identification of moving interaction forces with incomplete velocity information. , 2003 .

[22]  Tommy H.T. Chan,et al.  Dynamic wheel loads from bridge strains , 1988 .

[23]  A. N. Tikhonov,et al.  Solutions of ill-posed problems , 1977 .

[24]  S. S. Law,et al.  MOVING FORCE IDENTIFICATION: OPTIMAL STATE ESTIMATION APPROACH , 2001 .

[25]  O. Zienkiewicz.  The Finite Element Method In Engineering Science , 1971 .

[26]  W. Baumgartner,et al.  BRIDGE-VEHICLE INTERACTION USING EXTENDED FE ANALYSIS , 1999 .

[27]  Arturo González,et al.  Development of accurate methods of weighing trucks in motion , 2001 .

[28]  S. S. Law,et al.  Moving load identification on multi-span continuous bridges with elastic bearings , 2006 .

[29]  D. M. Trujillo.  Application of dynamic programming to the general inverse problem , 1978 .

[30]  Tommy H.T. Chan,et al.  Moving force identification: A time domain method , 1997 .

[31]  Xinqun Zhu,et al.  Vehicle axle loads identification using finite element method , 2004 .

[32]  Siu-Seong Law,et al.  Study on Different Beam Models in Moving Force Identification , 2000 .

[33]  Xinqun Zhu,et al.  Identification of Moving Loads on an Orthotropic Plate , 2001 .

[34]  Xinqun Zhu,et al.  IDENTIFICATION OF VEHICLE AXLE LOADS FROM BRIDGE DYNAMIC RESPONSES , 2000 .

[35]  H. R. Busby,et al.  Solution of an inverse dynamics problem using an eigenvalue reduction technique , 1987 .

[36]  D. M. Trujillo.  The direct numerical integration of linear matrix differential equations using pade approximations , 1975 .