Design and Spin Test of a Hybrid Composite Flywheel Rotor with a Split Type Hub

A study is conducted on lowering the radial tensile stresses and increasing the performance of the fiber wound composite flywheel rotor by applying pressure on the inner surface of the rotor using a split type hub that spreads in the radial direction due to the centrifugal force. A conventional solid or ring type hub in most cases produces tensile stresses within the rotor, possibly causing delamination and eventually lowering the maximum speed of the rotor. The relationship between the stresses of the rotor and the thickness of the hub is derived and applied to the single and hybrid rotors. A hybrid composite rotor of 180 mm inner diameter and 340 mm outer diameter is designed and fabricated, which reaches only the strength ratio of 0.58 at the maximum rotating speed of 40,000 rpm. A spin test was conducted to show the improved performance of the rotor with the split type hub by measuring the mechanical strains from the rotor. The radial and circumferential strains at four different locations are measured up to 30,000 rpm using a wireless telemetry system, and they are in good agreement with the analytical calculations. The rotor has survived a spin test of up to 40,000 rpm, which corresponds to the usable energy of at least 500 W h with the safety factor of 1.7.

[1]  Charles E. Bakis,et al.  Simplified Analysis of Residual Stresses in In-Situ Cured Hoop-Wound Rings , 1998 .

[2]  Nadar D. Ebrahimi Optimum design of flywheels , 1988 .

[3]  Y. Tarnopol’skii,et al.  Spin-tests of composite flywheels. A review , 1997 .

[4]  G. W. Vickers,et al.  Analysis of filament-wound cylindrical shells under combined centrifugal, pressure and axial loading , 1997 .

[5]  Sung K. Ha,et al.  Measurement and Prediction of Process-induced Residual Strains in Thick Wound Composite Rings , 2003 .

[6]  Gerard C. Pardoen,et al.  Achieving desirable stress states in thick rim rotating disks , 1981 .

[7]  S. Ha,et al.  Optimum Design of Thick-Walled Composite Rings for an Energy Storage System , 1998 .

[8]  John D. Herbst,et al.  Design, Fabrication, and Testing of 10 MJ Composite Flywheel Energy Storage Rotors , 1998 .

[9]  Sung K. Ha,et al.  Effects of Rotor Sizes and Epoxy System on the Process-Induced Residual Strains within Multi-Ring Composite Rotors , 2004 .

[10]  Tae Hyun Sung,et al.  Optimum design of multi-ring composite flywheel rotor using a modified generalized plane strain assumption , 2001 .

[11]  Charles E. Bakis,et al.  Optoelectronic strain measurement for flywheels , 2002 .

[12]  S. C. Han,et al.  Effects of material properties on the total stored energy of a hybrid flywheel rotor , 2000 .

[13]  T. Chou,et al.  Optimization of composite flywheel design , 1977 .

[14]  Håkan L. Wettergren,et al.  Delamination in composite rotors , 1997 .

[15]  Giancarlo Genta,et al.  Kinetic energy storage , 1985 .