Voltage coefficient of a piezoelectric nanocomposite energy harvester: modeling and experimental verification

Piezoelectric nanocomposites composed of piezoelectric nanowires and flexible polymer have emerged as outstanding applications for flexible energy harvester. Although piezoelectric materials in their bulk form have high electromechanical coupling coefficient and can convert mechanical energy to electrical energy efficiently, they usually have low fracture toughness and are limited in applications due to difficulty in machining and casting it on to curve surfaces. Recently, additive manufacturing process (direct write) have been developed to incorporate piezoelectric nanowires into a polymer matrix with controlled alignment. It is shown that not only direct writing method can solve these issues but also it can improve the performance of the nanocomposite energy harvester significantly. In this paper, an experimentally verified finite element (FE) and micromechanics models are developed for calculation and optimization of g31 voltage coefficient of a piezoelectric energy harvester nanocomposite. It is shown that, by using high aspect ratio nanowires with controlled alignment the g31 coefficient can be enhanced more than five times compared to bulk form. Moreover, it is demonstrated that to achieve highest possible g31 coefficient only a small volume fraction of nanowires is needed and further increase in volume fraction result in the reduction of g31 coefficient.

[1]  Henry A. Sodano,et al.  Effect of aspect ratio on the electroelastic properties of piezoelectric nanocomposites , 2009, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[2]  Li Min Zhou,et al.  Micromechanics approach to the magnetoelectric properties of laminate and fibrous piezoelectric/magnetostrictive composites , 2004 .

[3]  Daniel J. Inman,et al.  Energy Harvesting Technologies , 2008 .

[4]  M. Pindera,et al.  Micro-macromechanical analysis of heterogeneous materials: Macroscopically homogeneous vs periodic microstructures , 2007 .

[5]  M. C. Tracey,et al.  Mechanical characterization of bulk Sylgard 184 for microfluidics and microengineering , 2014 .

[6]  Toshio Mura,et al.  Micromechanics of defects in solids , 1982 .

[7]  Tungyang Chen,et al.  Mori-Tanaka Estimates of the Overall Elastic Moduli of Certain Composite Materials , 1992 .

[8]  Jiangyu Li,et al.  The enhanced and optimal piezoelectric coefficients in single crystalline barium titanate with engineered domain configurations , 2003 .

[9]  Gregory M. Odegard,et al.  Constitutive Modeling of Piezoelectric Polymer Composites , 2004 .

[10]  D. Jeulin,et al.  Determination of the size of the representative volume element for random composites: statistical and numerical approach , 2003 .

[11]  Haixiong Tang,et al.  Synthesis of High Aspect Ratio BaTiO3 Nanowires for High Energy Density Nanocomposite Capacitors , 2013 .

[12]  J. C. H. Affdl,et al.  The Halpin-Tsai Equations: A Review , 1976 .

[13]  Christian Hellmich,et al.  Ductile sliding between mineral crystals followed by rupture of collagen crosslinks: experimentally supported micromechanical explanation of bone strength. , 2009, Journal of theoretical biology.

[14]  Xin Zhang,et al.  Dielectric constants of PDMS nanocomposites using conducting polymer nanowires , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.

[15]  H. Kuo,et al.  Magnetoelectricity in coated fibrous composites of piezoelectric and piezomagnetic phases , 2013 .

[16]  Henry A. Sodano,et al.  Surface morphology effects in a vibration based triboelectric energy harvester , 2017 .

[17]  Daniel J. Inman,et al.  Estimation of Electric Charge Output for Piezoelectric Energy Harvesting , 2004 .

[18]  D. Inman,et al.  A Review of Power Harvesting from Vibration using Piezoelectric Materials , 2004 .

[19]  Yanlin Song,et al.  Direct Writing of Patterned, Lead‐Free Nanowire Aligned Flexible Piezoelectric Device , 2016, Advanced science.

[20]  Henry A. Sodano,et al.  Vertically aligned BaTiO3 nanowire arrays for energy harvesting , 2014 .

[21]  Z. Ounaies,et al.  Finite Element Analysis of a Three-phase Piezoelectric Nanocomposite , 2010 .

[22]  K. Tanaka,et al.  Average stress in matrix and average elastic energy of materials with misfitting inclusions , 1973 .

[23]  C. Della,et al.  On the performance of 1–3 piezoelectric composites with a passive and active matrix , 2007 .

[24]  Henry A. Sodano,et al.  The effect of particle aspect ratio on the electroelastic properties of piezoelectric nanocomposites , 2010 .

[25]  M. Taya.  Electronic Composites: Frontmatter , 2005 .

[26]  M. Taya.  Electronic Composites: Applications of electronic composites , 2005 .

[27]  Henry A. Sodano,et al.  Vertically aligned lead Titanate Nanowire arrays for high temperature energy harvesting , 2015 .

[28]  T. Yue,et al.  Modeling Young's Modulus of Polymer-layered Silicate Nanocomposites Using a Modified Halpin—Tsai Micromechanical Model , 2006 .

[29]  O. H. Ando Junior,et al.  A review of the development and applications of thermoelectric microgenerators for energy harvesting , 2018, Renewable and Sustainable Energy Reviews.

[30]  Jan Schjødt-Thomsen,et al.  The Mori–Tanaka stiffness tensor: diagonal symmetry, complex fibre orientations and non-dilute volume fractions , 2001 .

[31]  Y. Bansal,et al.  Micromechanics of spatially uniform heterogeneous media: A critical review and emerging approaches , 2009 .

[32]  H. Sodano,et al.  Electromechanical modeling and experimental verification of a direct write nanocomposite , 2019, Smart Materials and Structures.

[33]  M. Taya.  Electronic Composites: Modeling, Characterization, Processing, and MEMS Applications , 2005 .

[34]  Henry A. Sodano,et al.  Ultra-long vertically aligned lead titanate nanowire arrays for energy harvesting in extreme environments , 2017 .

[35]  Günter,et al.  Dielectric, elastic, piezoelectric, electro-optic, and elasto-optic tensors of BaTiO3 crystals. , 1994, Physical review. B, Condensed matter.

[36]  Y. Shu,et al.  Analysis of power output for piezoelectric energy harvesting systems , 2006 .

[37]  Zheng-ming Huang,et al.  A note on Mori-Tanaka’s method , 2014 .

[38]  Henry A. Sodano,et al.  Electromechanical modeling and experimental verification of a direct write nanocomposite , 2018, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.