Design of a new urban wind turbine airfoil using a pressure-load inverse method

This paper presents the design methodology of a new wind turbine airfoil that achieves high performance in urban environment by increasing the maximum lift. For this purpose, an inverse method was applied to obtain a new wind turbine blade section with constant pressure-load along the chord, at the design inlet angle. In comparison with conventional blade section designs, the new airfoil has increased maximum lift, reduced leading edge suction peak and controlled soft-stall behaviour, due to a reduction of the adverse pressure gradient on the suction side. Wind tunnel experimental results confirmed the computational results.

[1]  S. Obayashi,et al.  Genetic optimization of target pressure distributions for inverse design methods , 1996 .

[2]  Michael S. Selig,et al.  Blade design trade-offs using low-lift airfoils for stall-regulated HAWTs , 1999 .

[3]  J. L. Tangler,et al.  NREL airfoil families for HAWTs , 1995 .

[4]  I. H. Abbott,et al.  Theory of Wing Sections , 1959 .

[5]  J. Katz,et al.  Low-Speed Aerodynamics , 1991 .

[6]  Michael S. Selig,et al.  Wind tunnel aerodynamic tests of six airfoils for use on small wind turbines , 2004 .

[7]  Badreddine Kamoun,et al.  The inverse design of the wind turbine blade sections by the singularities method , 2006 .

[8]  M. Maughmer,et al.  Multipoint inverse airfoil design method based on conformal mapping , 1991 .

[9]  Antonio Filippone,et al.  Airfoil inverse design and optimization by means of viscous-inviscid techniques , 1995 .

[10]  Michael S. Selig,et al.  Desirable Airfoil Characteristics for Large Variable-Speed Horizontal Axis Wind Turbines , 1997 .

[11]  Michael S. Selig,et al.  Multipoint inverse design of an infinite cascade of airfoils , 1994 .

[12]  Gao-lian Liu,et al.  A new generation of inverse shape design problem in aerodynamics and aerothermoelasticity: concepts, theory and methods , 2000 .

[13]  W. A. Timmer,et al.  Summary of the Delft University Wind Turbine Dedicated Airfoils , 2003 .

[14]  Christian Bak,et al.  Development of the Risø wind turbine airfoils , 2004 .

[15]  M. Drela.  XFOIL: An Analysis and Design System for Low Reynolds Number Airfoils , 1989 .

[16]  Peter Fuglsang,et al.  Design of the wind turbine airfoil family RISØ-A-XX , 1998 .

[17]  L. Gato,et al.  Iterative use of a time-marching code for designing turbomachine blade rows , 1996 .

[18]  J. Hess.  Review of integral-equation techniques for solving potential-flow problems with emphasis on the surface-source method , 1975 .