Kiln drying behavior of lumber from ten fast-growth plantation species in Costa Rica

Abstract Plantation wood from tropical climate has been introduced rapidly in the national market; however, there is lack of knowledge about the process. The main objective of this study was to investigate the kiln drying behavior of 10 plantation-grown wood species from natural forest in Costa Rica using the recommended drying schedule. Initial moisture content (MCi), final moisture content (MCf), drying rate, drying time, and drying defects were evaluated. The drying schedule applied produced the following results: (1) high MCi (over 110%) in four species and lower values in two species. (2) The largest drying time was found in species with high MCi, and the shortest drying time in species with lower MCi. (3) Significant variations of target MCf were found in some species, despite equalization and conditioning. (4) Exponential relationship MC=a*ϵ−t*b was used to establish a moisture content (MC) decrease model, which is not a good indicator of drying time for fives species. (5) High incidence of drying defects was found in Alnus acuminata and Vochysia guatemalensis. According to the above results, it is necessary to test other drying schedule oriented to improve lumber quality and to decrease variability of MC in wood from plantation trees.

[1]  R. Moya,et al.  Kiln Drying of Acacia mangium Willd Wood: Considerations of Moisture Content before and after Drying and Presence of Wet Pockets , 2011 .

[2]  B. Bond,et al.  Moisture Content Variation in Kiln-Dried Lumber from Plantations of Vochysia Guatemalensis , 2011 .

[3]  F. Muñoz,et al.  Moisture content variability in kiln-dried Gmelina arborea wood: effect of radial position and anatomical features , 2008, Journal of Wood Science.

[4]  R. Moya,et al.  WET POCKETS IN KILN-DRIED GMELINA ARBOREA LUMBER , 2008 .

[5]  Süleyman Korkut,et al.  Comparison of Two Drying Schedules for European Hophornbeam (Ostrya carpinifolia Scop.) Lumber , 2007 .

[6]  R. Shmulsky,et al.  Influence of sawing solution and pith location on warp in 2 by 4 lumber sawn from small-diameter loblolly pine stems , 2007 .

[7]  R. M. Roque.  Wood of Gmelina arborea in Costa Rica , 2004, New forests.

[8]  R. M. Roque.  Effect of management treatment and growing regions on wood properties of Gmelina arborea in Costa Rica , 2004, New Forests.

[9]  B. Zobel,et al.  The changing quality of the world wood supply , 1984, Wood Science and Technology.

[10]  R. Gottfried,et al.  State Policies and the Preservation of Forest Cover: Lessons from Contrasting Public-Policy Regimes in Costa Rica , 2002, Latin American Research Review.

[11]  W. Simpson,et al.  Grouping Tropical Wood Species for Kiln Drying , 1999 .

[12]  J. R. Sprague,et al.  Juvenile Wood in Forest Trees , 1998, Springer Series in Wood Science.

[13]  W. Simpson,et al.  Relative drying times of 650 tropical woods : estimation by green moisture content, specific gravity, and green weight density , 1991 .

[14]  M. Milota.  Method for the measurement of bow and crook , 1991 .

[15]  E. M. Wengert,et al.  Dry kiln schedules for commercial woods: temperate and tropical. , 1988 .

[16]  Hiram Hallock,et al.  Sawing to Reduce Warp in Plantation Red Pine Studs. , 1972 .

[17]  M. E. Dunlap.  Electrical moisture meters for wood , 1944 .