Performance analysis of a novel sun-tracking CPC heat pipe evacuated tubular collector

Abstract A tracking compound parabolic concentrating (TCPC) solar collector with concentration ratio of 2.3, which combine the CPC, heat pipe evacuated tubular receiver and crank rod transmission mechanism together, was developed and studied in this paper. A theoretical model was created to simulate the solar incident angles and the optical performance of the TCPC collector. In addition, thermal performances of the TCPC collector at different operation modes were investigated experimentally. The simulation results show that, the transversal projection angle (θt) is the vital factor that affects the optical performance. When θt is within the range of −23.5° and 23.5°, the incident angle modifier (IAM) of the TCPC collector reaches 0.95∼1.14. By means of tracking, the average optical efficiency is over 60%, while it is decreased to 30% under the fixed mode (FM). The output energy of the TCPC collectors during the test period can be highly increased, which is 1.9∼2.3 times higher than that at the FM. Furthermore, the intermittent tracking mode (ITM) is more power frugal and efficient as the average optical efficiency is 3.6% higher than that at the Continuous tracking mode (CTM). These verify that the ITM is the optimal operation mode for the TCPC collectors.

[1]  A. Rabl.  Optical and thermal properties of Compound Parabolic Concentrators , 1975 .

[2]  Fabienne Sallaberry,et al.  Optical losses due to tracking error estimation for a low concentrating solar collector , 2015 .

[3]  Roland Winston,et al.  Principles of solar concentrators of a novel design , 1974 .

[4]  A. El Bouardi,et al.  Heat and mass transfer during adsorption of ammonia in a cylindrical adsorbent bed: thermal performance study of a combined parabolic solar collector, water heat pipe and adsorber generator assembly , 2004 .

[5]  Gang Pei,et al.  Comparative study on annual solar energy collection of a novel lens-walled compound parabolic concentrator (lens-walled CPC) , 2012 .

[6]  Réné Tchinda,et al.  Study of the C.P.C. collector thermal behaviour , 1998 .

[7]  Ruzhu Wang,et al.  Comparative study on two novel intermediate temperature CPC solar collectors with the U-shape evacuated tubular absorber , 2013 .

[8]  Chigueru Tiba,et al.  Optical and thermal optimization of stationary non-evacuated CPC solar concentrator with fully illuminated wedge receivers , 2011 .

[9]  Spiros Papaefthimiou,et al.  Cost effective asymmetric CPC solar collectors , 1999 .

[10]  K A Reed,et al.  Dependence of the solar absorptance of selective absorber coatings on the angle of incidence , 1977 .

[11]  Abdul Jabbar N. Khalifa,et al.  Effect of two-axis sun tracking on the performance of compound parabolic concentrators , 1998 .

[12]  C. K. Hsieh,et al.  Thermal analysis of CPC collectors , 1981 .

[13]  Yong Kim,et al.  An evaluation on thermal performance of CPC solar collector , 2008 .

[14]  Chigueru Tiba,et al.  Analytic solutions for the geometric and optical properties of stationary compound parabolic concentrators with fully illuminated inverted V receiver , 2008 .

[15]  Jeffrey M. Gordon,et al.  Economic Optimization of Stationary Nonevacuated CPC Solar Collectors , 1987 .

[16]  R. E. Jones,et al.  Optical properties of compound circular arc concentrators , 1978 .

[17]  Mervyn Smyth,et al.  Heat retaining integrated collector storage solar water heater with asymmetric CPC reflector , 2011 .

[18]  J. M. Pinazo,et al.  Analysis of the incidence angle of the beam radiation on CPC , 1992 .

[19]  Aniruddha B. Pandit,et al.  Cost effective design of compound parabolic collector for steam generation , 2013 .

[20]  W. R. McIntire.  Factored approximations for biaxial incident angle modifiers , 1982 .

[21]  Enrico Zambolin,et al.  Experimental analysis of thermal performance of flat plate and evacuated tube solar collectors in stationary standard and daily conditions , 2010 .

[22]  Jyeshtharaj B. Joshi,et al.  Performance analysis of a novel and cost effective CPC system , 2013 .

[23]  Philip C. Eames,et al.  Validated, unified model for optics and heat transfer in line-axis concentrating solar energy collectors , 1993 .

[24]  William A. Beckman,et al.  Solar transmittance characteristics of evacuated tubular collectors with diffuse back reflectors , 1985 .

[25]  R. Tang,et al.  Feasibility and optical performance of one axis three positions sun-tracking polar-axis aligned CPCs for photovoltaic applications , 2010 .