Phase change flattening process for axial grooved heat pipe

[1]  Yong Tang,et al.  Cold welding sealing of copper-water micro heat pipe ends , 2009 .

[2]  M. Akhanda,et al.  Experimental investigation of micro heat pipes of different cross-sections having same hydraulic diameter , 2008 .

[3]  Hanzhong Tao,et al.  Experimental study of heat transfer performance in a flattened AGHP , 2008 .

[4]  W. Q. Tao,et al.  An experimental investigation on a novel high-performance integrated heat pipe–heat sink for high-flux chip cooling , 2008 .

[5]  L. L. Vasiliev,et al.  Micro and miniature heat pipes – Electronic component coolers , 2008 .

[6]  Zhuang Jun.  Comparison of the Heat Transfer Performance in an AGHP with and Without 90° Bend , 2008 .

[7]  Yong Tang,et al.  Experimental study of oil-filled high-speed spin forming micro-groove fin-inside tubes , 2007 .

[8]  G. S. Sekhon,et al.  Study of lateral compression of round metallic tubes , 2005 .

[9]  Jong-Wook Kim,et al.  Heat pipe cooling technology for desktop PC CPU , 2003 .

[10]  Mahmoud Nemat-Alla,et al.  Reproducing hoop stress–strain behavior for tubular material using lateral compression test , 2003 .

[11]  Laila S. Bayoumi.  Analysis of flow and stresses in flattening a circular tube by rolling , 2002 .

[12]  Yuji Saito,et al.  Use of heat pipe/heat sink for thermal management of high performance CPUs , 2000, Sixteenth Annual IEEE Semiconductor Thermal Measurement and Management Symposium (Cat. No.00CH37068).

[13]  S. Chi.  Heat pipe theory and practice , 1976 .

[14]  I. M. Cole,et al.  A review of the longitudinal rolling of tube on two- and three-roll mills , 1970 .

[15]  Philip G. Hodge,et al.  Crushing of a Tube Between Rigid Plates , 1963 .

[16]  G. Foussereau,et al.  Comptes rendus des séances de l'Académie des Sciences et annales de chimie et de physique; 1892 , 1893 .