Capacitance signal analysis of horizontal two-phase flow in a small diameter tube

Abstract Two-phase flow modelling strongly depends on flow patterns. For the purpose of objective flow pattern identification, a capacitance sensor is developed for horizontal two-phase flow in small diameter tubes. The influences of the electrical properties of water and refrigerants upon the measurements are discussed, as well as the effect of temperature variations. The charge/discharge frequency of the transducer has to be matched with the electrical resistance and capacitance of the fluids. A test rig is constructed and a series of experiments is done with horizontal air–water flow in a 9 mm tube. Experimental results with tap water and demineralised water are compared. The sensor is able to characterise all main flow regimes described in the literature. Differences in sub-regimes were distinguished and described. Time-averaged sensor signal values, combined with the variances and a high frequency contribution factor, are studied to quantify the differences in flow pattern, in comparison to the visual discrimination. These parameters of the sensor signals are suitable for more objective flow regime discrimination.

[1]  Leonardo Goldstein,et al.  A procedure for correcting for the effect of fluid flow temperature variation on the response of capacitive void fraction meters , 2005 .

[2]  Kamiel S. Rezkallah,et al.  A capacitance sensor for the characterization of microgravity two-phase liquid-gas flows , 1999 .

[3]  M. Sami A. Abouelwafa,et al.  The Use of Capacitance Sensors for Phase Percentage Determination in Multiphase Pipelines , 1980, IEEE Transactions on Instrumentation and Measurement.

[4]  John R. Thome.  Two-Phase Heat Transfer Using No-Phase Flow Models? , 2004 .

[5]  M. Trela,et al.  Capacitance sensor for void fraction measurement in water/steam flows , 2004 .

[6]  Vice President,et al.  AMERICAN SOCIETY OF HEATING, REFRIGERATION AND AIR CONDITIONING ENGINEERS INC. , 2007 .

[7]  K. S. Rezkallah,et al.  Void fraction measurements in gas-liquid flows under 1 - g and μ - g conditions using capacitance sensors , 1997 .

[8]  P. B. Whalley,et al.  Slug flow regime identification from dynamic void fraction measurements in vertical air-water flows , 1997 .

[9]  Brian E. Williams,et al.  Comparison study of a cluster of four dynamic flow pattern discrimination techniques for multi-phase flow , 1999 .

[10]  Wuqiang Yang,et al.  A portable stray-immune capacitance meter , 2002 .

[11]  E. A. Hammer,et al.  Capacitance sensor design for reducing errors in phase concentration measurements , 1998 .

[12]  K. S. Rezkallah,et al.  Flow regime identification in microgravity two-phase flows using void fraction signals , 1999 .

[13]  S. Borg,et al.  CYRANO: a computational model for the detailed design of plate-fin-and-tube heat exchangers using pure and mixed refrigerants , 1997 .

[14]  D. Mewes,et al.  Multielectrode capacitance sensors for the visualization of transient two-phase flows , 1997 .

[15]  Maurice Beck,et al.  Conductivity effects on capacitance measurements of two-component fluids using the charge transfer method , 1988 .

[16]  J. C. Borst,et al.  A CAPACITANCE SENSOR FOR TWO-PHASE VOID FRACTION MEASUREMENT AND FLOW PATTERN IDENTIFICATION , 1988 .

[17]  J. Taylor.  An Introduction to Error Analysis , 1982 .

[18]  Kamiel S. Rezkallah,et al.  Void fraction measurements in gas - liquid flows using capacitance sensors , 1996 .

[19]  E. A. Harrington.  The Dielectric Constant of Aqueous Solutions , 1916 .

[20]  Marco Fossa,et al.  Design and performance of a conductance probe for measuring the liquid fraction in two-phase gas-liquid flows , 1998 .

[21]  Vikrant Aute,et al.  CoilDesigner: a general-purpose simulation and design tool for air-to-refrigerant heat exchangers , 2006 .

[22]  Brian E. Williams,et al.  Experimental comparison of flow pattern detection techniques for air-water mixture flow , 1999 .