Investigation of tribological behaviors of annular rings with spiral groove

Abstract A series of experiments is conducted to study the tribological behavior of spiral groove thrust bearings. The experimental system consists of a nominally flat upper ring mating with a stationary spiral groove lower ring in fully flooded lubrication environment. Spiral groove thrust bearings with different spiral angles subjected to different loads and speeds are tested. Stribeck-like curves are obtained and their characteristics are discussed. Transition points from mixed to hydrodynamic lubrication are experimentally established. In addition, a theoretical model is developed to gain further insight into the frictional characteristics of spiral grooves in both the hydrodynamic regime and the mixed lubrication regime.

[1]  Francis E. Kennedy,et al.  Applied Tribology: Bearing Design and Lubrication , 2001 .

[2]  G. S. Buck,et al.  Upstream pumping : a new concept in mechanical sealing technology , 1990 .

[3]  Michel Fillon,et al.  Experiments on Thermal Effects in a Hydrodynamic Thrust Bearing , 1998 .

[4]  H. Cheng,et al.  An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic Lubrication , 1978 .

[5]  Leif Floberg,et al.  Boundary Conditions of Cavitation Regions in Journal Bearings , 1961 .

[6]  Qin Zhu,et al.  A numerical procedure based on the boundary element method analysis of the archimedean Spiral Grooved Thrust oil bearing , 2000 .

[7]  S. B. Malanoski,et al.  The Static and Dynamic Characteristics of the Spiral-Grooved Thrust Bearing , 1965 .

[8]  J. Greenwood,et al.  Contact of nominally flat surfaces , 1966, Proceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences.

[9]  D. D. James,et al.  Numerical Analysis of the Gas-Lubricated Spiral-Groove Thrust Bearing-Compressor , 1967 .

[10]  H. Cheng,et al.  Application of Average Flow Model to Lubrication Between Rough Sliding Surfaces , 1979 .

[11]  Bernard Tournerie,et al.  Finite element analysis of grooved gas thrust bearings and grooved gas face seals , 1993 .

[12]  Michael M. Khonsari,et al.  Performance Analysis of Full-Film Textured Surfaces With Consideration of Roughness Effects , 2011 .

[13]  T. A. Harris,et al.  Rolling Bearing Analysis , 1967 .

[14]  Xiangfeng Liu,et al.  Study of Flow Characteristics of Lubricant in Spiral-Groove Bearings by the Fluorescent Method , 2005 .

[15]  J. H. Vohr,et al.  ON THE SPIRAL GROOVED, SELF ACTING, GAS BEARING, , 1964 .

[16]  Göran Broman,et al.  Implications of cavitation in individual grooves of spiral groove bearings , 2001 .

[17]  A. J. Smalley.  The Narrow Groove Theory of Spiral Grooved Gas Bearings: Development and Application of a Generalized Formulation for Numerical Solution , 1972 .

[18]  T. Lai,et al.  Development of non-contacting, non-leaking spiral groove liquid face seals , 1994 .