A study of microstrip transmission lines on substrates created using additive manufacturing and flexible or semi-rigid filaments

Additive manufacturing is becoming more affordable and in recent years new techniques on implementing this emerging technology into microwave circuits are being developed. Therefore, understanding the propagation behavior of printed microstrip transmission lines implemented with these manufacturing techniques is needed. In this paper, the use of flexible and semi-rigid filaments to create substrates using additive manufacturing for printed microstrip transmission lines is presented. In particular, NinjaFlex, PLA and Armadillo filaments are used to manufacture 1.57 mm thick grounded substrates for 50Ω microstrip transmission lines. The dielectric properties (i.e., complex permittivity) of these newly manufactured substrates are determined by comparing the following three results: (1) measurements with a Keysight N1501A-101 high temperature dielectric probe; (2) measurements of a known transmission line problem and (3) full-wave simulations. The results in this paper show a good comparison between the three aforementioned techniques and that a 50Ω printed microstrip transmission line can be created on substrates manufactured using the NinjaFlex, PLA and Armadillo filaments up to 3.0 GHz.

[1]  R. Rumpf,et al.  Broadband Microwave Frequency Characterization of 3-D Printed Materials , 2013, IEEE Transactions on Components, Packaging and Manufacturing Technology.

[2]  T. M. Weller,et al.  Development of Novel 3-D Cube Antennas for Compact Wireless Sensor Nodes , 2012, IEEE Transactions on Antennas and Propagation.

[3]  D. E. Anagnostou,et al.  A Self-Adapting Flexible (SELFLEX) Antenna Array for Changing Conformal Surface Applications , 2013, IEEE Transactions on Antennas and Propagation.

[4]  S. Noghanian,et al.  Dielectric property measurement of PLA , 2016, 2016 IEEE International Conference on Electro Information Technology (EIT).

[5]  R. Wicker,et al.  3-D Printed Microwave Patch Antenna via Fused Deposition Method and Ultrasonic Wire Mesh Embedding Technique , 2015, IEEE Antennas and Wireless Propagation Letters.

[6]  Craig Armiento,et al.  Microwave dielectric characterization of flexible plastic films using printed electronics , 2016, 2016 87th ARFTG Microwave Measurement Conference (ARFTG).

[7]  Ryan Bahr,et al.  Infill-Dependent 3-D-Printed Material Based on NinjaFlex Filament for Antenna Applications , 2016, IEEE Antennas and Wireless Propagation Letters.

[8]  D. Pozar.  Microwave Engineering , 1990 .

[9]  Craig Armiento,et al.  Design and Simulation of Fully Printable Conformal Antennas with BST/Polymer Composite Based Phase Shifters , 2016 .

[10]  Pedram Mousavi,et al.  Application of novel integrated dielectric and conductive ink 3D printing technique for fabrication of conical spiral antennas , 2013, 2013 IEEE Antennas and Propagation Society International Symposium (APSURSI).

[11]  J. Rogers,et al.  A Stretchable Form of Single-Crystal Silicon for High-Performance Electronics on Rubber Substrates , 2006, Science.