Application of Taguchi, Fuzzy-Grey Relational Analysis for Process Parameters Optimization of WEDM on Inconel-825

Process parameters optimization of multiple response characteristics of WEDM on Inconel-825 super alloy using Fuzzy- Grey relational analysis is presented in this paper. Response characteristics such as MRR, surface finish and spark gap are optimized during wire EDM operation. Process parameters including pulse on time, pulse off time, corner servo voltage, flushing pressure, wire feed, wire tension, servo feed and spark gap voltage are investigated using Taguchi mixed L36 orthogonal array. These response characteristics are studied and examined using grey-fuzzy approach and optimal combination of influential input parameters are discovered. Based on the results of verification experiments it is concluded that Taguchi, Fuzzy-Grey Relational Analysis can efficaciously be used to find the optimal combination of influential input parameters of WEDM. Hence, this paper supports that the suggested approach can be a useful tool to ameliorate the performance of WEDM on Inconel-825.

[1]  J. Deng,et al.  Introduction to Grey system theory , 1989 .

[2]  U. Çaydas,et al.  Use of the grey relational analysis to determine optimum laser cutting parameters with multi-performance characteristics , 2008 .

[3]  C. L. Lin,et al.  Optimisation of the EDM Process Based on the Orthogonal Array with Fuzzy Logic and Grey Relational Analysis Method , 2002 .

[4]  Ling-Ming Kung,et al.  Prediction of index futures returns and the analysis of financial spillovers - A comparison between GARCH and the grey theorem , 2008, Eur. J. Oper. Res..

[5]  C. L. Lin,et al.  Use of the Taguchi Method and Grey Relational Analysis to Optimize Turning Operations with Multiple Performance Characteristics , 2004 .

[6]  J. L Lin,et al.  The use of the orthogonal array with grey relational analysis to optimize the electrical discharge machining process with multiple performance characteristics , 2002 .

[7]  E. Ezugwu.  Key improvements in the machining of difficult-to-cut aerospace superalloys , 2005 .

[8]  Ji-Liang Doong,et al.  Optimization of the injection molding process of short glass fiber reinforced polycarbonate composites using grey relational analysis , 2000 .

[9]  Ko-Ta Chiang,et al.  The optimal process conditions of an injection-molded thermoplastic part with a thin shell feature using grey-fuzzy logic: A case study on machining the PC/ABS cell phone shell , 2007 .

[10]  David K. W. Ng.  Grey system and grey relational model , 1994, SICE.

[11]  N Tosun,et al.  Determination of optimum parameters for multi-performance characteristics in drilling by using grey relational analysis , 2006 .

[12]  Aitzol Lamikiz,et al.  On the influence of cutting speed limitation on the accuracy of wire-EDM corner-cutting , 2007 .

[13]  Amar Patnaik,et al.  Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method , 2007 .