Cutting Parameters Optimization for Surface Roughness in Machining of GFRP Composites using Taguchi’s Method

This article discusses the use of Taguchi’s method and Pareto ANOVA analysis for optimizing the cutting parameters in turning glass fiber reinforced plastic (GFRP) composites using a poly crystalline diamond (PCD) tool for minimizing surface roughness. The cutting parameters evaluated are cutting speed, feed rate, and depth of cut. An L27 orthogonal array, signal to noise ratio, and Pareto ANOVA analysis are used to analyze the effect of cutting parameters and its interactions. The experimental results suggest that the most significant process parameter is feed rate followed by cutting speed. The study shows that the Taguchi method and Pareto ANOVA are suitable for optimizing the cutting parameters with the minimum number of trials.

[1]  K. Palanikumar,et al.  Mathematical Model to Predict the Surface Roughness on the Machining of Glass Fiber Reinforced Polymer Composites , 2006 .

[2]  W. König,et al.  Machining of Fibre Reinforced Plastics , 1985 .

[3]  H. Takeyama,et al.  Machinability of Glassfiber Reinforced Plastics and Application of Ultrasonic Machining , 1988 .

[4]  Imtiaz Ahmed Choudhury,et al.  Application of Taguchi method in the optimization of end milling parameters , 2004 .

[5]  Else Eriksen,et al.  Influence from Production Parameters on the Surface Roughness of a Machined Short Fibre Reinforced Thermoplastic , 1999 .

[6]  K. Palanikumar,et al.  Assessment of factors influencing surface roughness on the machining of glass fiber-reinforced polymer composites , 2006 .

[7]  Dwayne Arola,et al.  Orthogonal cutting mechanisms of graphite/epoxy composite. Part II: multi-directional laminate , 1995 .

[8]  Y. S. Tarng,et al.  Design optimization of cutting parameters for turning operations based on the Taguchi method , 1998 .

[9]  T. G. Rogers,et al.  A Theory of Machining of Fiber-Reinforced Materials , 1971 .

[10]  Jae-Seob Kwak,et al.  Application of Taguchi and response surface methodologies for geometric error in surface grinding process , 2005 .

[11]  J. Ferreira,et al.  Machining optimisation in carbon fibre reinforced composite materials , 1999 .

[12]  Seeram Ramakrishna,et al.  Machinability study of carbon fiber reinforced composite , 1999 .

[13]  Shi-Jer Lou,et al.  In-Process Surface Roughness Recognition (ISRR) System in End-Milling Operations , 1999 .

[14]  R. Komanduri,et al.  Machining fiber-reinforced composites , 1997 .

[15]  Madhan Shridhar Phadke,et al.  Quality Engineering Using Robust Design , 1989 .

[16]  J. Paulo Davim,et al.  Multiple regression analysis (MRA) in modelling milling of glass fibre reinforced plastics (GFRP) , 2004, Int. J. Manuf. Technol. Manag..

[17]  R. Krishnamurthy,et al.  Machinability characteristics of fibre reinforced plastics composites , 1988 .