Poly(3-Methylthiophene) Thin Films Deposited Electrochemically on QCMs for the Sensing of Volatile Organic Compounds

Poly(3-methylthiophene) (PMeT) thin films were electrochemically deposited on quartz crystal microbalance QCM transducers to investigate their volatile organic compound (VOC) sensing properties depending on ambient conditions. Twelve different VOCs including alcohols, ketones, chlorinated compounds, amines, and the organosphosphate dimethyl methylphosphonate (DMMP) were used as analytes. The responses of the chemical sensors against DMMP were the highest among the tested analytes; thus, fabricated chemical sensors based on PMeT can be evaluated as potential candidates for selectively detecting DMMP. Generally, detection limits in the low ppm range could be achieved. The gas sensing measurements were recorded at various humid air conditions to investigate the effects of the humidity on the gas sensing properties. The sensing performance of the chemical sensors was slightly reduced in the presence of humidity in ambient conditions. While a decrease in sensitivity was observed for humidity levels up to 50% r.h., the sensitivity was nearly unaffected for higher humidity levels and a reliable detection of the VOCs and DMMP was possible with detection limits in the low ppm range.

[1]  Jing Wang,et al.  Mechanism for toluene detection of flower-like ZnO sensors prepared by hydrothermal approach: Charge transfer , 2015 .

[2]  Michele Penza,et al.  Electrochemically growth of Pd doped ZnO nanorods on QCM for room temperature VOC sensors , 2016 .

[3]  Marcelo A. Pereira-da-Silva,et al.  Enhanced Sensitivity of Gas Sensor Based on Poly(3-hexylthiophene) Thin-Film Transistors for Disease Diagnosis and Environment Monitoring , 2015, Sensors.

[4]  M. Ovadia,et al.  Investigation of near ohmic behavior for poly(3,4-ethylenedioxythiophene): a model consistent with systematic variations in polymerization conditions. , 2010, ACS applied materials & interfaces.

[5]  Guang Li,et al.  Template Free Synthesis of Hollow Ball-Like Nano-Fe2O3 and Its Application to the Detection of Dimethyl Methylphosphonate at Room Temperature , 2012, Sensors.

[6]  Gaetano Scamarcio,et al.  A Comparative Study of the Gas Sensing Behavior in P3HT- and PBTTT-Based OTFTs: The Influence of Film Morphology and Contact Electrode Position , 2014, Sensors.

[7]  Haiyang Li,et al.  Quartz crystal microbalance sensor array for the detection of volatile organic compounds. , 2009, Talanta.

[8]  B. H. Weiller,et al.  Hydrogen sensors based on conductivity changes in polyaniline nanofibers. , 2006, The journal of physical chemistry. B.

[9]  Metal complexes of vic-dioximes for chemical gas sensing , 2011 .

[10]  H. Yoon,et al.  Current Trends in Sensors Based on Conducting Polymer Nanomaterials , 2013, Nanomaterials.

[11]  Kenshi Hayashi,et al.  A Nano-Thin Film-Based Prototype QCM Sensor Array for Monitoring Human Breath and Respiratory Patterns , 2015, Sensors.

[12]  Salih Okur,et al.  VOC sensors based on a metal oxide nanofibrous membrane/QCM system prepared by electrospinning , 2014 .

[13]  Kwong-Sak Leung,et al.  A Survey of Wireless Sensor Network Based Air Pollution Monitoring Systems , 2015, Sensors.

[14]  Khalil Arshak,et al.  A review of gas sensors employed in electronic nose applications , 2004 .

[15]  S. Hosseini,et al.  Conducting polymer blends of polypyrrole with polyvinyl acetate, polystyrene, and polyvinyl chloride based toxic gas sensors , 2003 .

[16]  A Proposal for Calculating Occupational Exposure Limits for Volatile Organic Compounds Acting as Sensory Irritants on the Basis of Their Physicochemical Properties , 2010, Journal of occupational and environmental hygiene.

[17]  Radu Ionescu,et al.  Polycyclic aromatic hydrocarbon for the detection of nonpolar analytes under counteracting humidity conditions. , 2012, ACS applied materials & interfaces.

[18]  Devendra Kumar,et al.  Advances in sensors based on conducting polymers , 2006 .

[19]  Krishna C. Persaud,et al.  Polymers for chemical sensing , 2005 .

[20]  Sandeep Kumar Vashist,et al.  Recent Advances in Quartz Crystal Microbalance-Based Sensors , 2011, J. Sensors.

[21]  H. Haick,et al.  Spongelike structures of hexa-peri-hexabenzocoronene derivatives enhance the sensitivity of chemiresistive carbon nanotubes to nonpolar volatile organic compounds of cancer. , 2009, Langmuir : the ACS journal of surfaces and colloids.

[22]  Andrea Cusano,et al.  Carbon nanotubes-coated multi-transducing sensors for VOCs detection , 2005 .

[23]  J. Uzarski,et al.  Interactions and binding energies of dimethyl methylphosphonate and dimethyl chlorophosphate with amorphous silica. , 2012, Langmuir : the ACS journal of surfaces and colloids.

[24]  Hossam Haick,et al.  Sensor Arrays Based on Polycyclic Aromatic Hydrocarbons: Chemiresistors versus Quartz-Crystal Microbalance. , 2013, ACS applied materials & interfaces.

[25]  H. Haick,et al.  Carbon Nanotube/Hexa‐peri‐hexabenzocoronene Bilayers for Discrimination Between Nonpolar Volatile Organic Compounds of Cancer and Humid Atmospheres , 2010, Advanced materials.

[26]  A. Guadarrama,et al.  Influence of electrochemical deposition parameters on the performance of poly-3-methyl thiophene and polyaniline sensors for virgin olive oils , 2004 .

[27]  Young-Kyo Seo,et al.  Occurrence and Concentrations of Toxic VOCs in the Ambient Air of Gumi, an Electronics-Industrial City in Korea , 2015, Sensors.

[28]  Zafer Ziya Öztürk,et al.  A comparative study on the NO2 gas sensing properties of ZnO thin films, nanowires and nanorods , 2011 .

[29]  Z. Öztürk,et al.  Customized vic-dioximes and their metal complexes for enhanced chemical sensing of polar organic molecules , 2013 .

[30]  R M Nester,et al.  Occupational Safety & Health Administration , 1996, AAOHN journal : official journal of the American Association of Occupational Health Nurses.

[31]  Z. Öztürk,et al.  Vic-dioximes: A new class of sensitive materials for chemical gas sensing , 2011 .

[32]  John Mortensen,et al.  Polymer coated quartz crystal microbalance sensors for detection of volatile organic compounds in gas mixtures. , 2007, Analytica chimica acta.

[33]  Anuvat Sirivat,et al.  Electrical conductivity response of polypyrrole to acetone vapor: effect of dopant anions and interaction mechanisms , 2004 .

[34]  T. A. Jones,et al.  The role of catalysis in solid-state gas sensors , 1986 .

[35]  G. Korotcenkov.  Metal oxides for solid-state gas sensors: What determines our choice? , 2007 .

[36]  Lynn Fuller,et al.  A chemical sensor for chloromethanes using a nanocomposite of multiwalled carbon nanotubes with poly(3-methylthiophene) , 2005 .

[37]  Hakan Urey,et al.  Fabrication of 1D ZnO nanostructures on MEMS cantilever for VOC sensor application , 2014 .

[38]  Hua Bai,et al.  Gas Sensors Based on Conducting Polymers , 2007, Sensors (Basel, Switzerland).

[39]  Julian W. Gardner,et al.  Modelling of gas-sensitive conducting polymer devices , 1995 .

[40]  C. Visy,et al.  Deprotonation and Dehydration of Pristine PPy/DS Films during Open-Circuit Relaxation: an Ignored Factor in Determining the Properties of Conducting Polymers , 2003 .