论文信息 - Modeling and simulation studies of unified power flow controller based on power-injected method in PSASP

Modeling and simulation studies of unified power flow controller based on power-injected method in PSASP

This paper briefly introduces the basic principle of unified power flow controller (UPFC) and the PSASP user-defined modeling. Full consideration to the electrical characteristics of UPFC device and its energy transfer with the power system, established the power flow model of UPFC basing on the power injection method, then the power flow model of UPFC based on the Power System Analysis Software Package (PSASP) is built by use of the User-Define Modeling function of PSASP, and finally used the IEEE-14 bus system to show the feasibility and effectiveness of the model.

Zhi Yan | Yan Wang | Xiaoyan Song | Yuxin Yan

[1] Fang Dazhong,et al. Power flow analysis of power system with UPFC using commercial power flow software , 2000, 2000 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.00CH37077).

[2] Zhou Xiaoxin. USING THE METHOD OF INJECTING CURRENT FROM ADDITIONAL NODES FOR MODELING AND SIMULATION OF SSSC POWER FLOW CONTROLLER , 2005 .

[3] Ding Jian-yong. Power flow modeling of thyristor controlled series capacitors based on power system analysis software package , 2006 .

[4] M. Tumay,et al. Steady state analysis of unified power flow controller: mathematical modeling and simulation studies , 2003, 2003 IEEE Bologna Power Tech Conference Proceedings,.

[5] Liu Qian. POWER FLOW MODELING OF FACTS BASED ON PSASP , 2000 .

[6] Cheng Shijie. Modeling and Simulation of Parallel FACTS With Energy Storage in Power System Analysis Software Package , 2010 .